Active Member
|
[China]
Address: Floor 3rd,Liufeng Building,Liushi Town,Yueqing City,Zhejiang.325604.China
Contact name:Tess Wong
YUEQING WINSTON ELECTRIC CO.,LTD. |
|
|
Lumber / Furniture Cylindrical Proximity Sensor Ultrasonic UB400-12GM-E4-V CE
Description
Brife introduction of ultrasonic sensor
Ultrasonic sensors present the ideal solution for non-contact position and distance measurement in all industrial areas where environmental conditions such as dust, smoke or steam may affect the sensors. Objects consisting of a variety of materials can be detected to within millimeters regardless of color or shape.
The ultrasonic sensor produces a data carrier utilizing very high frequencies that are outside the human’s audible range. The time it takes for that ultrasonic wave to pass between the sensor and the object is the value for the distance or the position.
Ultrasonic sensors have proven their reliability and precision in many industries and applications, including:
Technical data
data |
General Specifications |
Sensing distance: 30…400mm |
Adjustment range: 50…400mm |
Unusable area: 0…30mm |
Standard target plate: 100mm×100mm |
Transducer frequency: About 310 kHz |
Response delay: About 50ms |
Indicators/Operating means |
LED blue Power on |
LED yellow indication of the switching state Flashing:program function object detected |
LED red permanently red: Error |
Electrical specifications |
Operating voltage UB10…30VDC,ripple10%ss |
No-load supply current: ≤30mA |
Input |
Input type 1 TEACH-IN input Operating distance, |
Output |
Output type : 1 switch output E5, NPN NO/NC, programmable |
Rated operational current 100mA,Short circuit/overload protected |
Default setting switch point A1:70mm Switch point A2:800mm |
Repeat accuracy : ±0.1% of full-scale value |
Voltage drop ≤ 3 V |
switching frequency ≤ 8Hz |
Range hysteresis 1% of the set operating distance |
Temperature influence: ±1.5% of full-scale value |
Ambient conditions |
Ambient temperature: -25…70°C(-13 ... 158 °F) |
Storage temperature: -40…85°C(-40 ... 185 °F) |
Mechanical specifications
|
Protection grade: IP67 |
Connection: V1 Connector M12x1,4-PIN |
Material Housing: brass,nickel-plated |
Transducer epoxy resin/hollow glass sphere mixture; Polyurethane foam |
Weight 25g |
Compliance with standards and di |
standard conformity EN60947-5-2:2007 |
External synchronization
The sensor can be synchronised by the external application of a
square wave voltage. A synchronisation pulse at the
synchronisation
input starts a measuring cycle. The pulse must have a duration
greater than 100 μs. The measuring cycle starts with
the falling edge of a synchronisation pulse. A low level > 1 s
or an open synchronisation input will result in the normal
operation
of the sensor. A high level at the synchronisation input disables
the sensor. Two operating modes are available:
1. Multiple sensors can be controlled by the same synchronisation
signal. The sensors are synchronised.
2. The synchronisation pulses are sent cyclically to individual
sensors. The sensors operate in multiplex mode.
Internal synchronization
The synchronisation connections of up to 5 sensors capable of
internal synchronisation are connected to one another. When
power is applied, these sensors will operate in multiplex mode.
The response delay increases according to the number of sensors to
be synchronised. Synchronisation cannot be performed
during TEACH-IN and vice versa. The sensors must be operated in an
unsynchronised manner to teach the evaluation limits.
Dimensions
Product picture
