Zhejiang THOR Electric Co., Ltd |
|
Cat.5 Cat.5e and Cat.6 Universal Network Surge Protector Maintain network speed and stability
Model: TRSS-RJ11 / 45
Color: white
Authentication: CE ECM
Product description
TRSS-RJ45/8 type network lightning arrester is a
lightning protection measure taken by Zhejiang tohr Electric Co.,
Ltd. to independently develop and manufacture the network system.
It is mainly used for lightning protection measures
against network system. It is an important manifestation of
internal lightning protection. In view of the characteristics of
the network system, the selection of high quality and low
capacitance gas discharge tube, TVS and other devices has the
advantages of small insertion loss, fast response speed, accurate
clamping, low output pressure and so on.
Product features
1. Greater traffic flow to improve safety
2. PCB is designed with microstrip, good isolation, low line
disturbance
3. Advanced production technology and beautiful appearance
4. The transmission distance can be transmitted by 100m!
Product specification
|
Working principle of product
The lightning arrester can effectively protect the
power equipment. Once the abnormal voltage appears, the lightning
arrester will play a protective role. When the protected device is
running under normal working voltage, the arrester will not work,
and it will be regarded as a circuit for the ground. Once the high
voltage is present and the insulation of the protected equipment is
endangered, the lightning arrester acts immediately and leads the
high voltage impact current to the earth, thus limiting the
amplitude of the voltage and protecting the insulation of the
electrical equipment. When the overvoltage is gone, the arrester is
restored to its original state quickly, so that the system can
supply electricity normally. The main function of the lightning
arrester is to reduce the voltage value of the protected equipment
through the action of parallel discharge gap or nonlinear
resistance, and to reduce the voltage value of the protected
equipment, so as to protect the power equipment.
Use of attention
1. The grounding wire should be short, thick and straight, so as to
reduce the influence of distributed inductance on the ability of
lightning electromagnetic pulse.
2. The input port (IN) of the lightning protector is
connected to the signal channel, and the output terminal (OUT) is
connected with the input end of the protected device, so it cannot
be connected to the reverse side.
3. The lightning protector of the network switch should
match the working voltage of the protected device. When installing,
please connect according to the installation sketch map.
4. There is no special maintenance for this product. The
lightning arrester should be checked regularly, especially in the
thunderstorm season and the whole thunderstorm period. When the
system fails to doubt the lightning arrester, the lightning
arrester can be dismantled and rechecked. If the system is restored
to normal after the restoration to the state before use, it
indicates that the lightning arrester has been damaged and must be
replaced immediately.
Product packaging:Carton packing
Transportation method
2. Trains, ships, aircraft transport