3.7v 7800mah Battery Operated Non Linear Junction Detector Low False Alarm Rate

Continuous wave mode 1.3 hours Non-Linear Junction Detector

Introduction

        The non-linear Junction Detector HW-24 is used to search and locate electronic devices in on or off state. When a radio frequency signal is detected, the non-linear junction detector generates second and third harmonics.Semiconductor components will display higher grades on the 2nd harmonic.Corrosive semiconductor components will display higher grades on the 3rd harmonic.The non linear junction detector analyzes the 2nd and 3rd harmonics reflected from the target to ensure the rapid and reliable identification of electronic components and corrosive semiconductors.

Features

1. The detector is easy to operate, it is an ideal security tool. Modulation mode: pulse wave, continuous wave, to ensure a wide range of detection and reliable analysis of electronic devices. Automatic control of output power makes operation very simple.

2.Automatic adjustment of detection emission power.The non-linear junction detector can automatically adjust the optimal reception frequency to avoid interference from external noise, thus ensuring good results in complex geomagnetic environment.

1. Electromagnetic radiation has little effect on people.The radiated power of the continuous carrier mode does not exceed 0.5W, and the maximum radiated power of pulse carrier mode does not exceed 10W. The level of radiated power is automatically controlled by an attenuator built into the device.

Specification