Active Member
|
[China]
Address: No. 28 Datong Road, Xuguan Town, Suzhou New District, P. R. China, Suzhou, Jiangsu, China
Contact name:Kaisa
Bohyar Engineering Material Technology(Suzhou)Co., Ltd |
|
|
Portable Cold Pipe Cutting And Beveling Machine Adjustable Cutting Speed
Trav l Cutter
The climbing pipeline cutting and beveling machine (Travel
Cutter) is the pipe processing equipment independently
developed by Bohyar based on the market and prospect of pipeline
service industry. The product is portable, precise, and efficient
and in modular design, fully meeting customer demands, it can cut
and bevel all common pipe materials, so this travel cutter is the
perfect choice for the cutting and beveling of various pipes.
■ Perfect cold cutting
It has been used in a wide range of applications, including natural
gas, crude oil and radioactive environments
■ Compact & portable design
Light weight, only 10"-12"gap, less than 10 minutes to install
■ A wide range of applications
Operate in the trenches full of silt and 25 meters underwater and
available for cutting and beveling in flooded trenches and
underwater mud at 600 feet.
■ Good stability
Strong corrosion resistance and durable structure
Tools
Model | TC0672 | Processing Range | 6"-72"(153mm-1829mm) |
Drive | Hydraulic | Wall Thickness | 5mm-25mm |
Hydraulic Requirements | 15 gpm @ 1500 psi. | Clearance | 254-305 mm (10"-12") radial, depending on pipe diameter. 20"axial(508 mm) |
Feed Method | Positive, non-slip chain drive. | Finish | Paint |
Cutter Speed | Adjustable 0-60RPM | Installation | Vertical or horizontal installation |
Operating Dimension | 610x510x280(mm) | Operating Weight | 100kg |
Hydraulic Control | Cutter on-off, feed on-off. Flow control valves which can adjust feed speed. Separate controls, providing adjustable feed and cutter speed. Forward/Reverse travel permits machine to be backed up. | ||
■ We have standard beveling tools of 30°, 37° and also can customize
the tools.
■ After the pipe is cut half, insert the steel wedge into the slit
of the cut pipe to prevent the pipe from clamping.
■ Sharp cutters will ensure safe, accurate, dependable cuts. Please
carefully observe whether the cutting tool is sharp before cutting.
■ The cutting condition will be drier when cutting cast iron and
ductile iron pipe. Usea thread cutting oil or a water soluble
cutting oil on steel and stainless steel pipe to lubricate the
cutters and help maintain sharpness.
■ Use specialized guide track when cutting in a vertical position or
when exact accuracy is required.
■ Adjust the feed rate to reduce or eliminate cutter overload. Feed
valve must be opened very slowly to achieve a slower feed rate. For
complete control of feed speed, install throttle valve in the feed
line.
■ The maximum effective cutting rate for the Travel Cutter on
ductile iron is approximately one minute per inch of diameter. Some
cast iron, steel, heavy wall pipe and beveling will require a
slower feed rate.
■ Make sure the work pieces are supported adequately for
installation of the equipment. This includes supporting any of the
work pieces “fall-off” section when serving the work piece.
Ensuring support of the work piece is the responsibility of the
operator.
■ Tools on any cutting equipment including drills, milling tools,
etc.-may get very hot. Do not touch the tools until you have made
sure it is not too hot to handle.
■ Before performing any service on the equipment, disconnect the
power source. Follow all procedures required at the worksite.
