BS65R Backstop Belt Conveyor 200RPM GCr15 Cam Clutch

               BS65R Backstop Belt Conveyor 200RPM GCr15 Cam Clutch

Features

The BS-R series offer easy lubrication maintenance.

1. Pre-insert the V-ring into the conveyor shaft in the correct direction.
2. Securely install the BS Cam Clutch onto the shaft. Apply the pressure only on the end face of the inner race

when inserting the BS Cam Clutch onto the shaft. Do not hit the inner race directly with a hammer or apply pressure

on the outer race. (Refer to page 13 for Installation and Usage)
3. Apply the sealant supplied, to the end face of the inner race and packing, and fix the BS Cam Clutch unit to

the conveyor shaft with the end plate. At the same time, use the seal washer on each bolt to prevent oil leakage.

Dimensions and Capacities

Notes:

1. BS-R Cam Clutch can be bored according to your specifications, but please specify the bore diameter with tolerance and keyway

dimensions.
2. Torque Arms are optional. The arm shown above is only for your reference. If necessary, please specify it on your order.

Mounting and Coupling

4. After cleaning the inside of the oil reservoir, apply the sealant on the mating face of the oil reservoir. Place the oil
level gauge vertically (red line is bottom, and blue is top),for models from BS65R to BS200R; install the oil reservoir
to the end face of the outer race with the bolts, while for models BS220R and above, install the oil reservoir to the
seal supporter using the bolts. Carefully prevent dust from penetrating the Cam Clutch or oil reservoir.
5. Press the pre-inserted V-ring entirely so that the face of the dust cover contacts closely.
6. In case the ambient temperature rises 40°C and above, it is recommended to set shield or roof and avoid direct

sunlight in order to extend the life span of Cam Clutch.

Pictures