Water based acrylic lamination adhesive

Low cost grade for common color box 

(Dry Lamination Glue / Heat seal lamination glue )

Brief introduction:

water based acrylic polymer adhesive designed for dry bond /heat seal laminating process.

Dry bond lamination is the process of coating the adhesive to plastic film,

drying the adhesive with heat and air flow and then laminating the adhesive to a second substrate (paper/paper board/cardboard etc..) via a heat compression nip.

Application:

For lamination of plastic film like PET, BOPP, MPET to printed paper or silver /gold cardboard.

Suit for dry /heat seal type manual and automatic laminating machine.

Advantage:

1. Lower consumption than oil / solvent based lamination adhesives.

2. water based adhesive, free of toluene, eco-friendly.

3, Easy to clean the lamination equipment.

Packing:

(1), 50kgs/Plastic drum, 20650kgs/1x20’GP without pallet. 13500kgs/1x20`gp withou pallet.

(2), 200kgs/drum,16000kgs/1x20’GP

(3), 1000kgs/IBC, 20000kgs/1x20’GP

Suggestion:

1, Before lamination, raise the temperature of the laminating machine roller to 95-110℃, the temperature of the drying tunnel to 80-95℃.

2, Pour the laminating adhesive into the glue tank, start the roller to keep the adhesive disperse on roller evenly,

The amount of adhesive consumption shall be flexibly adjusted according to the paper or film need to be laminated.

3, After complete drying the adhesive on film, the real temperature of the roller shall be 80-95℃, the roller pressure shall be around 6-20kgs.

4, the pressure roll shall be controlled flexibly to ensure no adhesive overflow from both sides of film and connections.

Notice:

1, Clean the adhesive tank and roller before use our adhesive;

2, Do not mix our adhesive with other adhesives;

3, Our adhesive only apply for BOPP film with corona over 38 Dyne ;

5, Better make testing for with film or paper, before mass production, to check the color retention or bonding strength;