Home Companies Nantong Zhonggang Coating Equipment Co., Ltd.

Bridge type drying chamber

Nantong Zhonggang Coating Equipment Co., Ltd.

Bridge type drying chamber

Country/Region China

Product Details

Bridge type drying chamber

Dryer - Maintenance
1. Day Maintenance
① a day with a soft cloth to wipe the device in order to maintain a neat appearance.
② boot day before checking triple gas source, when the oil level insufficient add oil and water in the exhaust.
③ every day to clean the dust inside the fluff, ensure good ventilation, the equipment to play the best drying results.
2. The monthly maintenance
① after opening the lid, use a soft cloth to clean the interior of the device.
② for bearings and other moving parts add oil to reduce friction.
③ Check the belt tension and adjust the pulley.
④ after shaking loose and fall off easily lead to the site, including electrical wiring, door rocker, pipe joints and so strong.
3. The annual maintenance
① Check base fixing bolts are loose and strong.
② Check the tightness of the connection and support spring when adjusted.
③ Check grounding equipment and ensure reliable.
④ check the computer control panel, wind turbine, the degree of flexibility of the heat exchanger.
⑤ thermometers and other instruments on the equipment sent to the local measurement and Technical Supervision.
4, Dryer Bearing Maintenance
Bearing crusher bearing shoulder the entire load of the machine, so good lubrication of the bearing life of a great relationship, it directly affects the life of the machine and the operation rate, which requires the injection of oil must be clean, seal must be good, this oiling the machine at the main
(1) rotary bearing (2) roller bearing (3) all of the gears (4) mobile bearing, a sliding plane.
1, the newly installed tire prone to loosening must always be checked.
2, note that the various parts of the machine is working properly.
3, pay attention to check the degree of wear parts wear, and pay attention to the replacement of worn parts.
4, put the active device chassis plane, dust and other materials should be removed to prevent the machine could not have broken material activities bearing on the chassis can not move, so as to cause a serious accident.
5, bearing temperature rise, the reasons should be eliminated immediately stopped and checked.
6. Turn the gear in operation should be immediately stopped if the impact of sound check and eliminate.

< BACK >

Hot Products

Automatic powder booth I. Overview Dusting refers to a corona discharge type powder coating adhesion ...
Tunnel drying chamber Tunnel dryer Tunnel dryer technical parameters: 1. Product Microwave Model: QX...
Microwave drying Microwave drying Microwave drying equipment, also known as the microwave dryer, ...
Dust-free drying I. Overview Was coated on the coating from a liquid (or powder) to a solid is ...
Straight-drying room I. Overview Was coated on the coating from a liquid (or powder) to a solid is ...
Bridge type drying chamber Dryer - Maintenance 1. Day Maintenance ① a day with a soft cloth to wipe ...