brand | Ning plastic | model | TNS-65 | Product alias | Pelleting machine |
Product use | Plastic granulation | Production capacity | 250(kg/h) | Number of rotating knife | (2) |
Fixed quantity | (2) | Turning diameter | 500(mm) | Inlet diameter | 500(mm) |
The filter sieve plate | 4(mm) | Cutting speed | 100(r/min) | Machine center high | 180 () |
An overview of the granulator is a kind of material can be made
into a particular shape molding machinery.Widely used in chemical, petrochemical, pharmaceutical, food,
building materials, mining and metallurgy, environmental
protection, printing and dyeing, ceramics, rubber, plastic, etc.According to the structure and working principle of a divided into
CF type rotary belt condensation granulator Flat twin screw
extruder roll drum drying production machine to dry granulator
(hereinafter referred to as the roller granulator) on tooth
granulating disc vacuum condensation granulator, etc
Range of application
Granulator in chemical industry are widely used in melting point
(softening point) in less than 300 ℃, condensing granulation of
various materials.Such as: sulfur, stone granulator wax, resin and asphalt, partial
acid, stearic acid, maleic anhydride;Phenolic resin, petroleum resin, modified resin and other resin
products;Hot melt adhesive, urea, synthesis soap, additives, rubber and
plastic additives and other products.
Matters needing attention
Attention granulator
One, the matters needing attention
1, the granulator is running;Avoid reverse.
2, granulator, avoid by all means cool machine running on an empty
stomach, it is necessary to heat engine charging operation, which
can avoid glue (axis) phenomenon.
3, pelletizer feeding port, are strictly forbidden in the vent hole
in the iron and other sundry.So as not to cause accident, affect production.
Second, the matters needing attention in the process of granulating
machine work
1, pay attention to the body temperature change at any time, with
clean hands touch the blade when not in hands, should immediately.Until the sliver hands as normal.
2, burn hand reducer bearing parts, or accompanied by noise should
be timely maintenance, adding fuel.
3, host on both ends of the bearing chamber bearing parts hot burn
hands or when there is noise, and infuse butter to stop.Normal work, bearing housing and once every 5 to 6 days with
butter.
4, pay attention to understanding the rules of the machine;Such as: temperature, speed fast, but according to situation,
handle in time.
5, the fuselage unstable operation, should pay attention to check
the shaft device of gap is too tight, should timely adjust loose
some.
Three, for the first time boot operation method
1, before starting, firstly heats up around four fifty minutes.Will increase temperature to hand pulling motor v-belts, until
freely;According to the normal working rotate to continuous pull eight to
ten times.Then continue to heat up ten minutes, and then boot, but will
continue to heat, because the normal production need replenishing
heat;According to the different nature of the plastic different
temperature adjustment.
2, pelleting machine work, machine temperature to remain stable,
high and low.Near the vent hole, until the nose position to maintain a
temperature of 200or so (c, b).
3, the material evenly and foot.Machine for feeding speed and feed speed to match the appropriate.O