Dcon / Modbus Serial RS485 Analog & Digital I/O ModulesI 7017 Input Type | +/-150mV, +/-500mV , +/-1V, +/-5V, +/-10V +/-20mA (requires optional external 125 ohm resistor) | I 7018 Input Type | +/-15mV, +/-50mV, +/-100mV, +/-500mV, +/-1V, +/-2.5V +/-20mA (requires optional external 125 ohm resistor) Thermocouple Type J, K, T, E, R, S, B, N, C | I 7013/33/15 Input Type | RTD ( 1/3/6 channel) | Wire connection | 2/3/4 wire | RTD Type | Pt100 a=0.00385, Pt100 a=0.003916, Ni120, Pt1000
a=0.00385 | I 7016 | 2 ch strain guage input | Input Type | +/-15mV, +/-50mV, +/-100mV,+/- 500mV , +/-1V,+/- 2.5V, +/- 20mA | Output Channels | 1 | Output Range | 0 to +10V | Max Output Load | 40mA | Accuracy | +/-0.05% of FSR | Drift | +/-50ppm/ °C | Output Impedance | 12 Ohms | Isolation | 3000 VDC | I 7021/22/24 Analog Data Acquisition system Output | 1/2/4 channel | Output Type | 0~20mA, 4~20mA, 0~5V, +/-5V, 0~10V, +/-10V | Resolution | 14-bit | I 7041/51/52/52 | 14 / 16/ 8 | Input Type | Sink or Source,Isolated channel with common power or ground | I 7042/43/45 | 13/16 | Output Type | Isolation Open Collector | Output Voltage | 30V max. | Output Current | 100mA per channel, Direct drive power relay module | Isolation Voltage | 3750V | I 7058/59 AC INPUT Module | 8 | Input Type | AC, Differential, isolated | Off Voltage Level | 30VAC max. | On Voltage Level | 80 ~ 250VAC | AC Frequency | 50~60Hz ( > 45Hz Min.) | Channels | 7 | I 7044/50/55D Digital I/O MODULE | Source, non-isolated channel with common ground | Off Voltage Level | +1V max. | On Voltage Level | +4V ~ +30V | Input Impedance | 3K9, 0.3W | Counters | channels7 | | Max. Counters16-bit (65535) | | Max. Input Frequency100Hz | | Min. Pulse Width5ms | Digital Data Acquisition system Output : | I 7044/50/55D Digital I/O MODULE |
|