6 Outlet Flat Plug Power Strip Metal PDU With Overload Protector IEC Approved

Power Tap IEC Approved by CE Power Strips , 6Way Extension Socket , Metal PDU with Overload protector
 
 
Key Specifications/Special Features:

• Voltage compatibility: 250VAC
• Output:
  • Frequency compatibility: 50/60 Hz
  • Output watts: 2,400
  • Output volt amp capacity (amps): 16A,10A, 13A
  • Outlet quantity/type: 6 way
  • Input:
  • Recommended electrical service: 16A,13A,10A,15A; 250V
  • Input plug features: IEC C-13
  • Input cord length (ft.): 5 to 25FT
  • Input cord gauge, type 1.5mm² x 3
• LAMP alarms and switches:
  • Switches lighted 2 position switch controls power to all outlets
  • Locking switch cover transparent on/off switch cover prevents accidental turn-off
  • Material of construction: aluminum
  • Mounting accessories included Includes mounting clips
  • Receptacle color: black
  • AC line cord color: black
  • Form factors supported: supports vertical or horizontal mounting in rack enclosures, raceways and a variety of other applications
  • Certificate: CE

 
INSTALLATION GUIDE:
Before installation, you may need to get a IEC C13 Outlet. Decide your wire gauge, and ask store attendant for assistance what color of connectors you should get) from your local hardware or electric supply or home improvement stores.
Minimum tools required: A fine to medium fine philips screw driver, and a pair of scissors, and a pair of mid size slip joint pliers

1. Turn off electricity in the house

2. Decide where to place this unit

3. Choose the side you want the cord exit to choose IEC C14 Built in power strips

4. Match the color of the wires and secure the wire connection with proper wire connectors built in IEC C13 plug.(different wire gauge use different colored wire connectors)

1. Mount the power strip where you want it to be:
   A) For power strips with mounting tabs on both ends: screw down the unit on the floor, wall or in your cabinet or on your rack, where you want it to be
   B) For power strips without mounting tabs, but to be mounted with clips, place the unit where you want it to be first, make marks where to install the clips, which normally should be placed about min 2”<power strips length away from each end, and then screw the clips down with screws provided. Then, snap the power strip in on the clips
2. Push IEC C13 outlet plug into IEC C13 inlet power strips , and push switch to ON. Turn electricity back on, you are ready to go.

Note:
We also custom manufacture for our customers.