Grey Car Body Filler Good Adhesion To Steel Metal Wood Surfaces

Easy To Scratch Grey Quick Dry Non-Shrinkable Car Body Filler

Description:

• MJ-COAT Body Filler’s are premium quality fillers that are formulated using the latest polymer technology.
• Its main uses are for premium repairs of automotive panels, caravans, trailers, boats, pools, spas and guttering.
• The filler is smooth, easy to apply, exhibits minimal surface tack, easy sanding and good featheredging.

DIRECTIONS OF USE

1. Make sure that application working area has been grinded to remove rough surfaces and all paint particles.

2. Clean the application working area of all particles (including moisture, dirt and grease).

3. Remove the required amount of filler and place on a clean mixing board. REPLACE THE LID OF THE FILLER IMMEDIATELY.

4. Prior to mixing, knead the tube of hardener. MAKE SURE HARDENER HAS NOT PAST SHELF LIFE.

5. A mixing ratio of 100:2 (100 parts filler to 2 part hardener) must be strictly used.

6. Mix all the filler and hardener for approximately 2 minutes, by incorporating all the hardener into the filler so that the mixed colour is uniform. BE SURE NOT TO MIX IN AIR. FOLD THE MIX, RATHER THAN STIRRING OR WHIPPING.

7. Use a clean applicator and apply the mixed filler to the application working area by spreading and folding the mix and overlapping several times over.

8. IMPORTANT: Discard all unused catalysed filler immediately from the mixing board and applicator before the filler gels.

9. The filler should gel in about 6-8 minutes at 20 Degrees Celsius.

10. Sanding can commence in approximately 20 minutes. MAKE SURE THE TOP LEVEL OF THE GELLED FILLER HAS DRIED COMPLETELY PRIOR TO SANDING. P40 to P320 sand paper range is recommended for sanding process.

11. See additional Auto Plus fillers available for your required application.

TYPICAL SUBSTRATES:

• Non-separating formula.
• Smoother texture. Easy to work with. 
• Quicker, easier filing. 
• Good adhesion to steel, metal, aluminum, fiberglass and wood surfaces.

SURFACE PREPARATION:

1. Clean surface. Remove all dirt, oil, grease and wax with a cleaning solvent such as Grease & Silicone Remover.

2. Make sure surface is dry before repairing.

3. Use 80 – 180 grit disc to featheredge paint for good mechanical adhesion.

DRYING/SANDING TIMES

• Allow the application of filler to cure 20 to 30 minutes.
• Sand with 80 grit sand paper and featheredge with 180 grit sandpaper or finer.
• Wait 1 hour before painting.
• Drying time depends on temperature and amount of hardener used.
• Optional: Apply a very thin layer of MJ-coat Glazing & Spot Putty to fill pinholes or small imperfections if necessary.