Mineral Insulated Electrical Tracing On Pipe

Mineral Insulated Heat Trace to Pistons, Valves, Pumps, Pipes, Pipe bends and Containers for Pharmaceutical Industry are used on the heat trace for the vessels like piston, valve, pump, pipe, bend and containers where the viscous media are stored and transported. Generally speaking, during normal production, electric heat tracing does not work. Only when the equipment is not running, the electric heat tracing system is turned on to ensure that the equipment can work normally when it is restarted.

MI armoured heating cable is made of single or multiple alloy electric heating wire as heating source, insulated with high purity, high temperature, electric melting crystallization magnesium oxide, sheathed by seamless continuous stainless steel or copper tube and formed using special production process. Used in highly corrosive places, PE or low smoke halogen-free coat can be added.

This heat tracing solution is suitable for explosion-proof, anti-corrosion areas, with the advantages of cost saving, environmental protection, easy installation and long service life etc.

Cable Structure

Specification

Heating cable instruction code

MI CU-B 16K320/60/2520/220/E1

No. 1 2 3 4 5 6 7

Cable Code

1 6 K 320

No. 1 2 3 4

Table 1 Structure of Cable Element

Note: Model C, F and G are suitable for being used at temperature under 65℃

Table 2 Heating Cable Specification (600V Single Conductor)

Table 3 Heating Cable Specification (600V Double Conductors)

Table 4 Heating Cable Specification (300V Double Cores)

Note: the resistance value of 2-core cable in the above table is the measured value after the ends are twisted (i.e., single-core resistance X2);

For the use of 660V voltage occasions, please contact our company professionals;

Mark of (300)☆ is a recommended production length by MICH

Table 5 terminal specifications

Note 1: E1 means 1/2 "NPT;E2 means 3/4 "NPT;E3 represents 1 "NPT (taper thread);Additional connection thread requirements are available.

Note 2: the length of cold end cable with standard configuration is 2 meters. If you increase or decrease of length required, please contact our professional personnel.

Corresponding reference table between the output power and sheath temperature

Note: when applying a copper conductor heating cable, please pay attention to the conversion of its heated hot resistance and unheated cold resistance.