45D Steel Pipe Bend

Carbon Steel 45D Bend, ASTM A234 WPB, 6 Inch, 20D Radius, SCH 40, ANSI B16.49, Beveled

Bend pipe is a complete set of bending equipment for bending, divided into cold simmer and hot push two processes. No matter which kind of machine equipment and pipeline, most of them are used to bend pipe, mainly for oil, gas, infusion, engineering bridge construction and so on.

Analysis of the main causes of the decrease in the quality of the bend pipe and the methods for attention:
When the 1. is pure bending, the outer arm wall of the neutral layer is thinned by tensile stress &1 under the action of M external force distance, and the inner compression stress. The joint force N1 and N2 make the cross section of the pipe change. On the basis of this factor, the main reasons for the decrease of bend pipe quality are RX and SX. Therefore, in the GBJ235-82, the RX value and the lateral thinning amount under various pressure grades are clearly stipulated. The purpose is to control the value of RX and SX to ensure quality.
As has been said in the front of the 2., the outside of the material is pulled when the bend is bent, and the position of the inner compression neutral shaft is different from the bend method. The neutral axis is 2/3 from the outer wall. Therefore, thin-walled pipe bending, the use of rotary bending method is beneficial.
3. the accuracy of bending tire is also one of the factors affecting the quality of bend pipe. In the manufacture of bending tire, in addition to the specification and size requirements to control in a certain tolerance range, but also require users to use according to the bending pipe diameter to select the corresponding bending tire.
4. bending property and surface corrosion of pipe itself may also affect the quality of bend pipe. During site construction, the operator should also understand the material, processing performance and surface corrosion of the pipeline.

5. R. available The curve of bending radius / tube diameter is used for reference when selecting the relationship between pipe diameter and wall thickness. Reflecting the influence of relative bending radius and relative wall thickness on the quality of bend pipe, according to the acceptance code of pipe processing: cold bending steel pipe, medium and low pressure 4 D, high pressure 5 D. Therefore, our bending tire design is R=4 D( special case), so the pipe bender produced by our factory mainly chooses the relative wall thickness SX, the upper part of the drawing is the coreless shaft area, the middle part of the drawing is the ordinary core shaft area, and the lower part of the drawing is the special core shaft area. Because the special core shaft design and manufacture are very difficult, the operation is not very convenient, so I generally do not supply. Special circumstances may be agreed upon separately.