IP65 Rated PIR Motion Detector with 12m mounting height for UFO highbay

IP65 Rated PIR Motion Detector with 12m mounting height for UFO highbay
 
 
Product Feature】

• Thimble interface;Earphone interface; Zhaga interface
• 12 meters maximum installation height, suitable for most warehouses
• Mini Microwave motion detector for High Bay Lights.
• IP65 design
• Sensor parameters can be adjusted by remote
• High mounting PIR sensor

            
   
 
【Parameters】

 
【Function description】

 
【Product Information】

• Dimension (Unit:mm)

• Function

• Wiring

           MC079D IR A               MC079D IR DI                MC079D IR Z

• Installation Instruction

 

 
【Detection Range】

 
【Remote】

• MH12

• MH10

 
【Initialization】

After switch on power,sensor will be warmed 45-60s then start to work.

 
【Default setting】

Sensitivity: 100%, Hold time: 5s, Daylight sensor: Disable, Stand by period: 0s

 
【Application Notice】

• The sensor should be installed by a professional electrician. Please turn off the power before installing, wiring and changing parameters.
• PIR sensor can’t penetrate any materials, please make sure no obstacle between sensor and moving people/object.
• Sensor may hard to detect people if wear thick clothes in cold winter.
• Heat signals will be regarded as moving signals to trigger the sensor. Avoid facing sensor to air condition or other heating source.
• Sensor is for indoor use only. Outdoor sunlight could affect the detection of sensor.
• Due to continuous improvement, the contents of this instruction could be changed without prior notice.
• The dimming performance could be different when work with different 0-10V drivers.
• The daylight threshold is measured in a sunny environment without shadow and ambient light diffuse reflection. Ambient lux level could be different in different environment, weather, climate, time-of-day and season.
• Detection distance is related to height of people, mounting height, mounting angle, working environment,and etc.
• Given detecting area is typical value that was measured by 165cm high testers in an indoor open environment.
• This product have to use with voltage-stabilized DC power supply whose input voltage is stable and ripple factor is low(ripple factor is lower than 100mV; load current is greater than 25mA).
• When installing in new environment, please install and test at least 5pcs product firstly before mass installation.