Active Member
|
[China]
Address: Room 608P,6th Floor,Xuyuan Building,No.5003, Longgang Road,Longgang District ,Shenzhen518116
Contact name:cindy
Lu’s Technology Co., Limited |
|
|
Model:
Li-Polymer battery 402025
3.7V rechargeable batteries
Polymer lithium battery PL402025
Lithium ion battery
Li-ion Polymer Battery
LP402025 3.7V Lithium Polymer Battery 150mah
Lithium Polymer Battery Li ion Major Application:
1)MP3/MP4 player, bluetooth, speakers, car GPS and all possible electronics products
2)Widely applied in Telecommunications, Audio and Video Devices, Information Devices...Etc.
Li-Polymer battery Product Advantages:
1) Environmental friendly
2) High density of energy
3) Light weight
4) Low self-discharge
5) Low internal resistance
6) Long cycle life, chargeable up to 500 or 1000 times
7) No memory effect
8) Doesn’t contain Mercury, No fire, No explosion, No leakage
9) Very good and quick charge, capability can be charged to 90% within 10 min.
10) Thickness can be adjusted while width and height keep the same
Specification:
No.
| Item
| General Parameter
| Remark
| |
| 1 | Rated Capacity
| Typical
| 150mAh | Standard discharge(0.5C5A) after Standard charge
|
Minimum
| 140mAh | |||
| 2 | Nominal Voltage
| 3.7V | Mean Operation Voltage
| |
| 3 | Voltage at end of Discharge
| 2.5V | Discharge Cut-off Voltage
| |
| 4 | Charging Voltage
| 4.2±0.03V | ||
| 5 | Internal Impedance
| ≤250mΩ | Internal resistance measured at AC 1KHZafter 50% charge
| |
| 6 | Standard charge
| Constant Current 0.2C5A/20mA Constant Voltage 4.2V 0.01 C5A cut-off
| Charge time : Approx 6.0h
| |
| 7 | Standard discharge
| Constant current 0.5C5A /50mA end voltage3.0V
| ||
Standard Test Conditions:
Test should be conducted with new batteries within one week after shipment from our factory
and the cells shall not be cycled than five times before the test.
Unless otherwise specified, test and measurement shall be done under temperature of 20±5℃
and relative humidity of 45~85%.
If it is judged that the test results are not affected by such conditions, the tests may be
conducted at temperature 15~30℃ and humidity 25~85%RH.
Appearance
There shall be no such defect as flaw, crack, rust, leakage, which may adversely affect
commercial value of battery.
li Ion Lithium Polymer Battery 3.7V 150mah LP402025:
