Active Member
|
[China]
Address: 618, Goodbond Venture Base, No.18, Lu Yun Road, Yue Lu District, Changsha City, Hunan Province
Contact name:cody
Hunan Heou Engineering Consulting Co., Ltd |
|
|
New Trend Universal EPP10MS lightning-proof plugs and sockets
General Description
EPP10MS power supply lightning protection socket is used for power
protection of small distribution equipment with indoor 220VAC power
supply, such as computer network, precision equipment, small
machine room, bank savings, office, monitoring machine room and
power protection of various power equipment; equipped with three
multi-functional output jacks, independent switch and internal
fault indication.
Adopt multi-level protection circuit, core components selected from international ****, stable performance.
Large through-current capacity, low port clamp voltage and sensitive response.
Easy installation, no special maintenance, long service life.
Aging thermal decoupling and short-circuit overcurrent decoupling, with visual warning indicator.
Technical parameters
Model
EPP10MS
Applicable grid
220VAC (50Hz)
SPD test grade
T2
**** Continuous operating voltage Uc
275VAC
Rated discharge current In(8/20μs)
5kA
**Maximum discharge current Imax(8/20μs)
10kA
Voltage protection level up [L-PE/N-PE/L-N
1.5kV/0.6kV/1.0kV
Enclosure material
White flame retardant plastic
Protection mode
Full protection
Size specification
176mm×73mm×38mm
Functional features
Independent jack introduction structure, flame retardant and insulated
Working environmental conditions
Temperature range: -40℃～+70℃ Humidity range. 30%～85% (25℃)
Connection method
1,When using, plug directly into the wall socket or other power output jack.
2,Please make sure the PE terminal of the plugged socket is reliably grounded, or the rack itself is reliably grounded (the socket shell is connected to the internal PE terminal).
Caution
1,The rated load current of lightning protection socket is 16A.
2,The grounding wire of the machine room or independent equipment room should be as thick and short as possible, and the grounding resistance should be less than 4Ω.
