smart glass, PDLC glass, electric control glass,PDLC Switchable
Film
How to make smart glass / Swichable glass
Name | Specification | size | Unit | | Delivery time |
PDLC | Standard film | 0-1800mm | SQM | | 3-7Days |
pasted film | 0-1500mm | SQM | |
|
1, glass preparation.
After get the required smart glass size, we make the appropriate
size of the glass, and according to the need to decide whether the
glass edging and edging forms; smart glass with the film
already belong to the safety glass composite, and most of the time
Less use of toughened glass saves money and saves time. However, if
it is necessary to use toughened glass for transportation or
customer needs, it should be possible to control the flatness of
the glass during toughening.
2, The size of the film must be smaller than the size of the glass.
Usually each side of the diaphragm is about 2mm smaller than the
glass, if the condition of the glass edge can be masked during
installation, then it can be a little bigger, but each edge should
not exceed 4mm, to avoid the stress effect; if the glass is spliced
together, Then 2mm is more appropriate, otherwise it will affect
the appearance.
3, Combining the film process.
Switchable glass and other laminated glass and the process is very
close, first of all the glass to be one side of the piece clean,
and then put a film; check the film for impurities, and impurities
removed; the Switchable film protection The film is unfolded, and
then the clean Switchable film is placed on the glass on which the
film has been placed in good position; another layer of film is
placed to check whether the film has impurities and the impurities
are removed; and another clean glass , And finally cut out the
excess film (if it is tempered glass to be thick film). Please note
that in the process, it is necessary to check whether the
Switchable film has moved due to your operation. If it is adjusted
at any time, the Switchable film can be bent and can be wrapped,
but it can not be recovered if there is any damage.
4, according to your plastic processing technology, the whole
process of vacuum.
5, After the processing is finished, wait for the glass to cool to
room temperature, then stop the vacuum and remove the glass, modify
the edge and energize the test.
6, Above all, if you follow these to operate has been able to
produce a standard dimming glass, and if you want to improve the
product, please contact us.
Packaging Details
Customized or wooden case
Delivery Time
3~7 days after receiving payment