Home Companies JSUS ELECTRONIC TECHNOLOGY CO.,LIMITED

5.8GHz microwave motion sensor LED ceiling light, IP66 waterproof, with 3 hours emergency pack

JSUS ELECTRONIC TECHNOLOGY CO.,LIMITED
Active Member

Contact Us

[China] country

Address: No.17-3L,Heyue Mansion,Longgang Avenue,ShenZhen City,Guangdong Province,P.R.China

Contact name:Jenny Lin

Inquir Now

JSUS ELECTRONIC TECHNOLOGY CO.,LIMITED

5.8GHz microwave motion sensor LED ceiling light, IP66 waterproof, with 3 hours emergency pack

Country/Region china
City & Province shenzhen guangdong
InquireNow

Product Details

  1. 5.8GHz microwave motion sensor LED ceiling light
    Power source: 100-240V/AC, 50/60Hz
    Rated LED: 15W or 20W
    3.5W max (DC)
    Charging power: <4W max (light off & light on)
    HF system: 5.8GHz
    Battery: 7.4V/1500mAh lithium battery
    Continuous illumination time: ≥180min
    Transmission power: <0.2mW
    Time setting: 5sec to 10min (adjustable), self-adjustable by DIP switch
    Detection range (max): 16m(D)*6m
    Detection sensitivity: 10%/50%/75%/100%
    Hold time: 5s/90s/3min/10min
    Corridor function: 0s/30s/10min/disable
    Daylight sensor: 5 lux/15 lux/50 lux/disable
    Standby dimming level: 20%, can be customized.
    Mounting height: 6m (max)
    Suggested installation height: 2.5-6m
    MV motion detection: 0.5-3m/s
    Detection angle: 150° (wall installation), 360° (ceiling installation)
    Working temperature: -20 - +45°C
    Power factor: >0.9
    IP66 water proof
    PC base and PC cover
    With built-in HF sensor + 3 hours emergency
    Size: Φ355*118mm

    High quality of microwave sensor driver used:
    1: ISM 5.8GHz, ISM wave band
    2: MV sensors are CE, TUV, RoHS and R&TTE approved.
    3: 100% stable.
    4:Detection area, time delay and daylight control precisely set via DIP switch, flexible adjustment and self-controlled.
    5: 3 years warranty.
    6:Large detection area with 16m Dia ×6m
    7:3-step dimming function
    8: Automatic on-off
    With sufficient ambient light, the sensor dose not switch on the lamp.
    With Insufficient ambient light, the sensor switches on the lamp when motion is detected.
    After hold time, the lamp gradually dims down if no motion detected.

Hot Products

产品特点及功能 ◆ 无线紧急按钮具有紧急报警触摸发送功能,在关键时候可起到紧急呼救的作用. ◆ 待机时间长,适应范围广. ◆ 采用无线信号传输,无需布线. 技术参数 工作电压:DC3V(CR2450纽...
产品特点及功能 ◆ 全密封防水外壳无需担心浸水. ◆ 探头抗氧化. ◆ 无线调频+跳频信号报警,无线抗干扰能力强. ◆ 电池供电,功耗低,使用时间长. ◆ 无需连线,安装简单,不受交流电源停电影响. ...
产品特点及功能: ◆ 太阳能(室内灯光)供电设计,无需外接电源线,2到5年无需更换电池 ◆ 待机电流小至微安级. ◆ 采用433MHz FSK+跳频无线信号,解决了无线信号容易被干扰和误收误报的问题. ...
产品特点及功能: ◆ 太阳能(室内灯光)供电设计,无需外接电源线,3到5年无需更换电池 ◆ 采用美国微芯公司的光电感烟探测专用芯片,可用于对各类早期火灾发出的烟雾做出报警. ◆ 光学迷宫,光电探测方式...
产品特点及功能: ◆操作真人语音提示,中文和英文可选. ◆采用高可靠性催化燃烧式传感器. ◆可显示燃气浓度(PPM). ◆交流供电和内置可充电电池(选配)双电源不间断供电. ◆微处理器智能控制. ◆传...
产品特点及功能: ◆ 无需外接电源线,1-2年无需更换电池. ◆ 待机电流小至微安级. ◆ 抗电磁,强光,小宠物干扰,误报率极低. ◆ 两级灵敏度可调,自动温度补偿,能根据环境温度的变化自动调整灵敏度...