Anping Jiechang Wire Mesh Products Co.,LTD |
|
Nickel Wire Mesh/Nickel screen is made of high purity nickel wire. It has outstanding
resistance to acids and alkalis. Nickel Wire Mesh is widely used in
corrosive environments as for filtration of liquid, gas, etc.
Plain woven nickel wire mesh is one of the most populary used mesh
type. It has outstanding stability and filter precision properties.
The characteristics of plain woven nickel wire mesh:
Each weft wire passes over one and under one warp wire, and each
warp wire passes over one and under one weft wire, every weft wire
have and warp wire the same diameter. Fabric shall be formed by
spacing the main and cross wires at a right angle. When the entire
main and cross wires are parallel and equally intervals, the mesh
forms a square, and, when the width is different, it becomes
rectangular.
Nickel Wire Mesh available material grades:
Pure Nickel with purity >99.5% | Nickel 200 | Nickel 201 |
Nickel Wire Mesh Specifications:
Wire Diameter: 0.05mm-16mm
Mesh: up to 250mesh/inch
The mesh can be produced according to customer's requirements.
Nickel Wire Mesh Characteristics
1: Good resistance to corrosion in acids and alkalis and is most
useful under reducing conditions.
2: Outstanding resistance to caustic alkalis up to and including
the molten state.
3: Virtually immune to inter granular attack above 315ºC, chlorates
must be kept to a minimum.
4: In acid, alkaline and neutral salt solutions the material shows
good resistance, but in oxidizing salt solutions severe attack will
occur.
5. Resistant to all dry gases at room temperature and in dry
chlorine and hydrogen chloride may be used in temperatures up to
550ºC.
6. Resistance to mineral acids varies according to temperature and
concentration and whether the solution is aerated or not. Corrosion
resistance is better in de-aerated acid.
Special specifications can be produced by the customer's requirements.