Active Member
|
[China]
Address: 307, 6A, ANGU Industrial Park, No. 8, Dongwang Road, SIP, Suzhou, Jiangsu Province, China 215 123.
Contact name:Rocky
Sinotectronics Inc. |
|
|
10.1 Inch Master Touch Windows/ Android/ Linux System ITO GG Touch Panel
1. Product Description
MST G + G Capacitive Touch Panel is made of a surface tempered glass and a ensor glass with Pcap technology. Capacitive touch panel works through body's current induction .When finger is on or close to touch panel surface,due to body electric field, the user and touch panel surface forms one coupling capacitance. For high frequency current, capacitance is direct conductor, then fingers suck a small current from the contact point, through amplifying and accurately calculating this current signal, the controller works out the touch point position.
2. Basic Features
| Item | Feature | Remarks |
| Controller | ILI2511 | - |
| Channel | TX: 23 RX: 37 | - |
| Power | 5V | USB: 4.7V ~ 6.0V, Typical:5V |
| Communication | USB | USB: 2.0 Full Speed |
| Number of Touch point | 10 | - |
| O.S. | Windows/ Android/ Linux | plug and play |
| Power Consumption | 1.Active Mode: Max.120mA @ USB Input 5V 2.Idle Mode: 90mA @ USB Input 5V 3.Sleep Mode: less than 1mA @ USB Input 5V | |
| Item | Specification | Unit |
| Viewing Area | 217.98(L)×136.6(W) | mm |
| Cover Lense O.D. | 254.96 (L)×173.6(W) |
4. Optical Characteristics
| Item | Specification | |
| Transparency | Viewing Area | ≧85% |
| Item | Specification | Unit | ||
| Stacked structure | Cover | 2.8 | mm | |
| LOCA | 0.2 | mm | ||
| ITO | 0.7 |
mm
| ||
| Sensor Glass | ||||
| ITO | ||||
| Sensor Dimension | OD Size | X | 227.5 | mm |
| Y | 149 | mm | ||
6. Drawing
7. Details
8. Cosmetic Inspection
The following standard only applies to the visual areas. If the TP
function is good, the non-visual appearance may negotiate to relax
the standard. W=Width L=length D=Diameter GT=Glass thickness. If
soft cloth which dips in alcohol can wipe besmirch, it does not
apply to this appearance standards.
Inspection methods and conditions:
1)Inspection environment: Temperature:20-22 ℃; Humidity: 65 + 10%
RH;
2)Inspector qualifications: The appearance of product must be
inspect by a good eyesight inspector.
3) Inspection methods: The distance between inspector and product should be 30±2cm and putting a lamp 12 to 20 watts of cold white fluorescent lamp in the observation station of product.
Pay attention to the following matters when inspection:
A.Inspectors must wear a fingerstall.
B.Put the product in front of inspector, hands hold the edge of
products carefully and can’t make it bended.
C.Inspectors shouldn’t stare at a certain point but continue
covered watching.
D.According to the following standards judge whether products conform to the requirement. If found other defect, from perspective of appearance consider whether customers accept this defect in end product.
9. FAQ
