|
[China]
Trade Verify
Address: 23E BlockB,Lushan Building，Chunfeng Road,Luohu District,Shenzhen,518001,China
Contact name:Eva
Shenzhen Wisdomlong Technology CO.,LTD |
|
Verified Suppliers
|
|
|
GE FANUC IC697CHS790 , 9-Slot Rear Mount For IC697 Programmable Controller Used For CPU And I/O Configurations
The IC697CHS790 is a 9-slot Rear Mount for IC697 programmable
controller used for CPU and I/O configurations. There is capability
for one power supply for the standard 9-slot rack located at the
leftmost module position. The IC697CHS790 rack mounts in a 10 inch
deep enclosure where fans are not normally required. The rack’s
dimensions are 11.15” H x 19” W x 7.5” D with controller slot width
being 1.6” W and the width of the supply slot at 2.4” W. Each rack
offers a slot sensing for rack-type I/O created for the IC697 PLC.
No switches or jumpers on the I/O modules are needed.
The mounting for the IC697CHS790 rack requires enough space to allow for proper cooling of system modules. The requirements for mounting must be determined according to the application and the proper rack ordered. The mounting flanges are conveniently factory installed in the rack’s side panels.
The IC697 I/O modules interlock by use of a key to avoid unintended interchange of a module type for another module type. Each module includes a key that latches on mechanically to the center rail of the rack, where it stays until the module is removed. If the module is not the correct type, it cannot be inserted into that rack slot. A rack number from 0-7 must be assigned when there are several racks in a system; the CPU rack is always rack 0. The number of each rack will be determined by the PLC from the four jumpers on the rack’s backplane. The backplane location is directly behind the power supply, and the jumpers are on the backplane.
| Module Type: | Standard Rack |
| Mounting Location: | Rear(panel) |
| Number of Slots: | 9 (plus power supply) |
| Type: | Double width |
| Dimensions: | 11.15 x 19.00 x 7.5 in. (H x W x D) |
| Internal Power Used: | 20 amps @ 5 VDC |
| Number of Slots | 5 or 9, plus power supply slot |
| Maximum 5 Volt Current | 20 amps (100 watt 120/240 VAC or 125 VDC power supply) 11 amps (55 watt 120/240 VAC or 125 VDC power supply) 18 amps (90 watt 24 VDC power supply) 18 amps (90 watt 48 VDC power supply) |
| Current Required from I/O Bus | 0.5 amps |
| I/O References | User configurable without the use of module jumpers or DIP switches. |
| Rack Identification | Four jumpers behind rack power supply |
Dimensions Nine Slot Rack | Height Width Depth 11.15” 19.00” 7.5” 283mm 483mm 190mm |
| Five Slot Rack | 11.15” 12.6” 7.5” 283mm 320mm 190mm All modules for the IC697 I/O system extend 1.7” (43mm) beyond the front of the rack. |
| VME | System designed to support the VME standard C.1 |
