|
[China]
Trade Verify
Address: 23E BlockB,Lushan Building，Chunfeng Road,Luohu District,Shenzhen,518001,China
Contact name:Eva
Shenzhen Wisdomlong Technology CO.,LTD |
|
Verified Suppliers
|
|
|
1PC Yaskawa Electric AC Servo Motor 100Watt 200VAC 0.318N.m SJME-01AMA41
Specifications
Current: 0.84A
Volatge: 200V
Power : 100W
Rated Torque: 0.318N-m
Max speed: 3000rpm
Encoder: 17bit Absolute encoder
Load Inertia JL kg¡m2¢ 10−4: 0.026
Shaft: straight without key
OTHER SUPERIOR PRODUCTS
Power lines and signal lines shall neither be threaded from identical tube nor banded. While wiring, distance between power lines and signal lines
Strand wire and strand integrated shielding wire shall be used for signal lines and encoder (PG) feedback lines, With respect to length of wire, command input line can not exceed 3m and PG feedback line can not exceed 20m.
Even power supply is OFF, there may be still high voltage remaining in servo driver, please do not touch power terminals for a while.
Power supply shall not be frequently turned ON/OFF. If it is needed to turn ON/OFF power supply continuously, the frequency shall be controlled below 1 times/min Since there are capacitors in power supply of servo driver, there is large charging current flow (charge time 2.0s) at the time of turning ON power supply. Therefore, if power supply is frequently turned ON/OFF, performance of main circuit parts within servo driver will be degraded
When motor is used on site with water or oil drops, special treatment shall be performed for protection. However, when shaft-through is needed to be sealed, motor with oil seal ring shall be specified. Shaft-through refers to the clearance of extruding part at the end face of motor
Electrical wires can not be bended or applied with strain. Excessive concentricity warp will cause vibration which may harm bearings. While installing the coupling, motor shaft can not be hammered directly, otherwise the encoder on the other side of motor may be damaged. www.adtechcn.com 12 Especially core wires of signal lines are 0.2 or 0.3 mm which is very thin, such that stretching can not be over tight at the time of wiring.
