Quantum I / O Power Interface Module 1544 Mbit / S Transmission Rate 140CRA93100

Redundant Power Supply Module Modicon RIO Drop Adapter Module 140CRA93100
 
 
 
 
Main
range of product
Modicon Quantum automation platform
product or component type
RIO drop adaptor module
Complementary
product compatibility
Quantum number of I/O expansion module   <= 27
type of cable   Coaxial 75 Ohm
transmission rate   1544 Mbit/s
dynamic range   35 dB
isolation voltage   500 V DC coaxial center and ground
electrical connection   1 female connector F elbowed with single cable
diagnostics startup
RAM address/data
Executive checksum
Power up and runtime
power dissipation in W     3 W 1 channel
bus current requirement    600 mA 1 channel
module format   Standard
Environment
resistance to electrostatic discharge
4 kV contact conforming to IEC 801-2
8 kV on air conforming to IEC 801-2
resistance to electromagnetic fields
10 V/m 80...1000 MHz conforming to IEC 801-3
ambient air temperature for operation    0...60 °C
ambient air temperature for storage    -40...85 °C
relative humidity    95 % without condensation
operating altitude     <= 5000 m
Offer Sustainability
Sustainable offer status     Green Premium product
RoHS (date code: YYWW)
Compliant - since 0901 - Schneider Electric declaration of conformity Schneider Electric declaration of conformity
REACh    Reference not containing SVHC above the threshold
Product environmental profile    Available End of life manual
Product end of life instructions    Available
Contractual warranty
Warranty period   18 months

OTHER SUPERIOR PRODUCTS

 
 
 
 
 
 
Rio Drop Adaptor Module Modicon Quantum - 1 Connector With Single Cable
Quantum | 140CRA93100 | Modicon | 140 CRA 931 00 | RIO Drop S908 1CH
The Remote I/O Drop Single Channel modules are used to transfer data bi-directionally over a coaxial cable network between I/O modules installed in the same (RIO drop) backplane and the RIO head installed in the CPU backplane. Two rotary switches are located on the rear panel of the RIO Drop Modules and are used for setting RIO drop addresses. SW1 (top switch) sets the upper digit (tens) ; SW2 (bottom switch) sets the lower digit (ones).
 
 
 
 
Dimensions of Modules and Racks
 
 

(1) 2 slots
(2) 3 slots
(3) 4 slots
(4) 6 slots
(5) 10 slots
(6) 16 slots
 
 
 

A fault light appears to be on my 140CRA93100, what does it mean?

The card is not seeing one or more of the IO modules configured for the drop. A module could be in the wrong slot or missing, it also could mean that it has failed. If the IO module is functioning correctly, the word "Active" will appear at the top of the module. If none of the IO modules are "Active" it could be that the address switches at the back of the CRA are not set up correctly. If all modules have the word 'Active', it could be that the Power Supply model number that is in the slot does not match the one in the configuration.