Lightweight Industrial Robot Servo Motors SGMGH-44ACA61 4400W1500r / Min

 
Industrial Servo Motor YASKAWA ELECTRIC SGMGH-44ACA61 4400W 1500r/min
 
 
Has the correct model of Drive beendelivered?
Check the model number on the nameplate on the right side of the Drive.Reconcile with packing slip and/or order information.
Is the Drive damaged in any way?
Inspect the entire exterior of the Drive to see if there are any dents, scratches orother damage resulting from shipping.
Are any screws or other componentsloose?
Use a screwdriver or other tool to check for tightness.
 
 
 
 

Item Description

• Manufacturer: Yaskawa
• Model #: SGMGH-44ACA61 or SGMGH44ACA61
• AC Servo Motor
• RPM: 1500
• AMP: 32.8
• 4400W
• 1500RPM
• Item Weight: 55 lbs
• original made in Japan
• ac servo motor
• with connectors and cable

• Function:Control

• High Speed

• Rated Torque:28.4Nm

 
Yaskawa Sigma 2 (?-II Series) Three-phase - 32.8A, 4400W, 200V, 4.4kW Servo Motor
Yaskawa | Sigma 2 (?-II Series) | Servo Motor
Repair for Yaskawa Sigma 2 (?-II Series) is available. MRO is committed to customer satisfaction!
 
 

OTHER SUPERIOR PRODUCTS

 
 
 
 
 
 
If there are any irregularities in the above items, contact the shipping company, the distributor or representative who sold the Drive, or a Yaskawa office immediately.
 
 
The E7 is thoroughly tested at the factory. Any damages or shortages evident when the equipment is received must be reported immediately to the commercial carrier that transported the material. Shipping damage is not covered by the Yaskawa warranty. After unpacking and inspecting for damage, verify that internal wire connections have not come loose during shipment by spot checking wire terminations with a screwdriver or the appropriate tool.
 
 
E7 Drive storage must be in a clean and dry location. Maintain the factory packaging and provide covering as needed to protect the E7 from construction site dirt, water, debris and traffic prior to and during construction.
 
 
 
Open Chassis Type (IEC IP00)
Protected so that parts of the human body cannot reach electrically charged parts from the front when the Drive is mounted in a control panel, also called (protected chassis).
 
NEMA Type 1(IEC IP20)
The Drive is shielded from the exterior, and can thus be mounted to the interior wall of a building (not necessarily enclosed in a control panel). The protective structure conforms to the standards of NEMA Type 1 in the USA. All protective covers (Fig 1.4) must be installed to conform with IEC IP20 and NEMA Type 1 requirements.