|
[China]
Trade Verify
Address: No. 1, Keyuan Road, Baiyun District, Guangzhou,Guangdong,,China
Contact name:Vivi
Guangzhou Guomat Air Spring Co., Ltd. |
|
Verified Suppliers
|
|
|
One Convoluted G1 Air Fittings Contitech FS 330-14 CI M8 Blind Nuts Air Spring For Self-propelled Sprayers
Specifications and Detailed Technical Parameters
1. Min Height: 55mm
2. Max Height: 160mm
3. Max. OD: 325mm
4. Air Fittings: G1
The distance between the air inlet and screw center: 66mm
5. Blind nuts on top plate: 2×M8×1.25
The distance between the blind nuts on top plate: 157.5mm
6. Blind nuts on bottom plate: 2×M8×1.25
The distance between the blind nust on bottom plate: 157.5mm
7. Top plate diameter: 231mm
8. Bottom plate diameter: 231mm
9. Bumper: Without
10. Girdle hoop: Without
Cross Reference
Air spring supplier: Contitech
Supplier number: FS 330-14 ; FS 330 14; FS
33014; FS330-11 CI; FS330-14CI; FS33014CI
| Type | Order No |
| Rubber bellows only | 62054 |
| With clamped plates G1 air inlet 66mm excentrical | on request |
| With clamped plates G3/4 air inlet 73mm excentrical | 67875 |
| With clamped plates G1/4 air inlet 73mm excentrical | 61937 |
| With bumper, clamped plates G1/4 air inlet 73mm excentrical | on request |
Application
This air spring can be used in Self-propelled Sprayers.
The air spring damping design is adopted on the self-propelled sprayer, and the flexible damping effect is good. The obvious advantage of the air spring is that under the most bumpy conditions, the air spring can provide cushioning and automatic adjustment without the need for the driver to make too many adjustments. It is more balanced and greatly improves production efficiency.
Convoluted air spring
An air spring is a carefully designed rubber/fabric bellows which
contains a column of compressed air. The rubber bellows itself does
not provide force or support load. This is done by the column of
air. Below is the air spring components.
1. AIR INLET
1/4" NPT is standard. 3/4" NPT is also available for most parts.
2. BLIND NUT
3/8-16 UNC thread x 5/8" deep (two or four per each plate depending
on part size). Used for mounting the part.
3. UPPER BEAD PLATE
Permanently crimped to bellows to form an airtight assembly which
allows for leak testing before the unit leaves the factory.
Zinc/chromate plated for rust protection.
4. GIRDLE HOOP
Wire wound type shown, molded into the bellows.
Our standard two ply air spring bellows is actually made up of four
layers: a. An inner liner of calendered rubber. b. One ply of fabric reinforced rubber. c. A second ply of
fabric-reinforced rubber (with the cords at a specific bias angle
to the first ply). d. An outer cover of calendered rubber
5. BELLOWS
6. LOWER BEAD PLATE
Usually the same as upper bead plate, except without air inlet.
The related picture Air Spring
