Gray FFP2 Respirator Mask , FFP2V Face Mask For Dust Protection

CE FFP2 Respirator Mask , Valved Dust Mask , With Valve With Carbon ,EN149:2001+ A1 : 2009

1 . Descriptions 

FFP2V Dust Mask with Steel nose clip,two head straps.In compliance with the norm EN 149:2001+A1:2009 ,PPE III CATEGORY and Shell-shaped.Have 4-plys, PP spunbond outer layer,actived carbon fiber filtration middle layer,PP meltbrown high filteration layer(94%), PP spunbond inner layer.

2 . Mask CE Quality Standards

                                1 . Stardard : EN : 149 : 2001 + A1 : 2009

                                2 . Test Machine : TSI 8130

                                3 . Test Flow : 95Liters/Min

                                4 . Test Medium : NACL & DOP

3 . Warning

• The user should be trained in the fitting and should be aware of the instructions for using prior to donning the respirator.
• Use in adequately ventilated areas,which are not deficiency of oxygen.
• Do not use this respirator when oxygen concentration is less than 19.5%.
• Do not use the mask in explosive environment.
• The mask must be fitted correctly to ensure the level of protection expected is achieved.
• The facila hairs or heards and certain facial charactrtistics may reduce the effectiveness of the mask.
• For mask mark marked “NR”,the particle filtering half mask shall not be used for more than one shift.

4 . How to use?

• Cup respirator in one hand with nosepiece at fingertips,allow headbands to hang freely below hand.
• Hold respirator under chin,with nose piece up
• Locate the upper strap across the crown of the head and the lower strap below the ears.
• Strap must not be twisted
• Using both hands,mould nose clip to the shape of the lower part of the nose to ensure a close fit and good seal.Pinching the nose clip using only one hand may result in less effective respirator peformance.
• The seal of the respirator on the face should be fit-checked before entering the workplace.
• If the user feels the bottom strap is too loose and it is not possible to achieve a satisfactory fit of the mask a knot can be tied in the strap.

​

5 . Discard and replace the mask if:

• The mask is removed whilst in the contaminated area.
• Clogging of the respirator causes breathing difficulties.
• The mask becomes damaged.
• For respirators protecting against vapours,the smell of vapours present becomes derectable.

6 . More pictures