Uric Acid Home Glucose Monitors 60s Multifunction

Blood Glucose Cholesterol Uric Acid Multifunction Analyzer With Strips

Application

This product is applied to monitor the concentration of blood glucose uric acid cholesterol in peripheral whole blood or venous whole blood of human body in vitro. This product is only used for daily self-monitoring. The test results cannot be considered as the basis of clinical diagnosis screening and medication guidance.

Coding the 3 In 1 Multifunction Analyzer

The meter should be coded before testing with the strips for the first time, or every time a new box of the test strips is used. Each box of test strips has an assigned code number. Every time a test strip is inserted, please be sure to check the code number appearing on the screen is the same as the code number marked on the box.

Start to use the 3 In 1 Multifunction Analyzer

1. Unscrew and remove the cover of the lancing device.

2. Insert the lancet into the lancet holder.
3. Twist and remove the protective lancet cover to expose the sterile needle tip.
4. Recapping and screwing the cover to the body of the lancing device.
5. Pull back on the cocking mechanism until it comes to a stop.
6. Adjust the puncture depth by rotating the lancing device caver. There are a total of 5 puncture depth settings.
7. Place the lancing device firmly against the fingerstick and press the release button. Gently squeeze your fingerstick until a round drop of blood forms. Wipe away the first drop of blood. Allow a new drop of blood to form.

8. After sampling, remove the lancet from the lancing device. Discard the used lancet into an appropriate sharps or biohazard container.

9. With the Multi function blood glucose meter turned off, insert a test strip into the test slot. The analyzer will turn on automatically with a"beep"sound and the screen will show all symbols. The code number will be shown on the screen after the symbol“--”shown. Be carefully to make sure the code number is the same as the code number marked on the test strip label.

10.  Meter shows the blood drop applying signal and the strip symbol on the screen, touch the sample inlet of the test strip to the blood drop until the analyzer sounds a“beep”that indicate a sufficient sample has been applied.

11. The“-”signal will be shown, and then the screen will display a countdown. After counting down,a“beep”sound will be heard. The screen will display the test results, and the result will be stored in the analyzer memory.