0.4mm-1.6mm Wire Take Up Machine , AC 15KW 1200m/min Copper Wire Down Coiler

HXE-WF750 Copper Coiler wire take up machine

I. Main technical parameter

1. Applicable diameter 0.4mm-1.6mm

2. Motor AC 15kw, Speed 1200m/min, adjustable

3. Coiler basket size 750mm

4. Small electric cabinet, 1 set, to connect with the drawing machine control system

5. Tension device required, if your drawing machine has Tension device, then no need.

6. Traverse motor AC 1.5kw

7. Speed reduction motor 90w

8. Speed control by Inverter 15kw

9. Air compressor shall be needed during working

10. Basket changing system is equipped

11. Basket block device is equipped

11. All ladders and blockers (Yellow parts) (Screws to fix) will be removed before shipping

12. The down half part of the Coiler will be removed before shipping

13. Needs connection wires from the Coiler to the drawing machine control system

II. Application

      WF750 Copper Coiler wire take up machine is used to take up wire from 0.4mm-1.6mm.

III. Lifting the machine, installation, adjustment

3-1.Lifting, there are four lifting rings to lift.

3-2.Installation, please check the external drawing and foundation drawing of the machine, dig the ground, put the machine in position, check the horizontal level, adjust the ground screws, put concrete slurry, after dry and fix, check the horizontal level again, then fix the machine by the ground screws.

3-3.Adjustment, clean all parts, check all the part no loose.

IV. Preparation before working

4-1.Check all parts lubrication conditions,

4-2.Check drawing lubrication oil, cooling water, steam, air pressure.

4-3.After checking, connect to power, according to the Electrical drawing, use foot switch, to make the machine operating in low speed (under 4m/s), if no Abnormal, then can begin to work.

V. Advantage and after-sale service

A: Advantage

(1). HENGXIE has some world famous parts suppliers, has special lubrication system for the gears and bearing.

(2). Body and other key components and parts are produced by our own factory , quality is reliable.

(3). Our company’s developing process in more than 10 years.

B: After-sale service

Our company for all machine product, since the shipment date, our company free after sale maintenance service guarantee period is:

(1) 1 year for mechanical part.

(2) 6 month for electrical part.

VI. Machine maintenance and precautions

1. Make sure the machine and the capstans clean, no scrap, no break wire.

2. Make sure the Take-up part clean.

3. Electrical cabinet should be closed.

4. Change belts if worn out.

5. Only qualified electrical technician can repair the electrical part.

6. Never change the Inverter parameter.

7. If something wrong with the machine that can`t solve, please contact the supplier first.

Do not open the machine without consulting to the supplier.

8. Put lubrication oil to the parts regularly, to make sure all parts running fluently. After running 1000 hours, clean all the bearings.

9. Annealed nickel belt and Annealing carbon brush are consuming parts. If spark happens a lot on the annealing capstans, then should change the nickel belt. If the carbon is going to run out, then need to change a new set.