Active Member
|
[China]
Address: Room 702-3,Ningbo Lishi Commercial building,Lane 578,45# Tiantong South Road,Yinzhou District,Ningbo,China
Contact name:Tina Kui
VAINO INTERNATIONAL LIMITED |
|
|
Shampoo bottles Plastic Blow Molding Machine double station 2 Layer
Brief introduction
CO-EXTRUSION BLOW MOLDING MACHINE FOR MULTI-LAYER BOTTLES
Applicable for single and double station with single to multiple die heads for producing up to SIX-LAYER CONTAINERS (2 TO 6-LAYER CO-EXTRUSION), such as chemical bottles, catchup bottles, or cosmetic bottles.
2Layer material will be:
Outer layer:PE/PP
inner layer:REPE/REPP
you can decrate your bottle with outer-layer (materbatch),inner layer (virgin or recycle material) to save cost and strength the body.
Advantage:
Piling out system adopting high performance transducer to drive ,saving power by above 30%,can be equipped with 100points wall ,thickness control ,Adopting foreign famous brand MOOG, improving the uniformity of the finished products ,lowering the weight of the finished products ,Flow and pre-sure proportional control valve. consuming less power ,high output ,of high performance price Ratio.
With self-functioned and stable PLC control system ,as well as the integrative of the machine ,electric devices and hydraulic digital controlled and temperature control of PID have been achieved ,The equipment’s operation speed and stability have been greatly improved ,Friendly operational panel ,easy, convenient
Shaft insertion structure can work with many models of machines with many die head ,of standardized design ,easy to adjust ,accurate of body separate shaft head design ,can be replaced easily ,high quality products
Center distance introduction:
Double head standard Center distance:140,85,110,125mm as option)
Thriple head standard center distance:80mm
Four head standard center distance:80mm
Machine specification:
| SPECIFICATION | Unit | MP55 |
| Material | PE,PP,(PVC,PA,PC)OPTION | |
| Max container capacity | L | 2 |
| Number of die | set | 1-6 |
| Machine Dimension(L×W×H) | M | 2.87×2.14×2.28 |
| Total weight | ton | 3.5 |
| Clamping force | kn | 30 |
| Platen opening stroks | mm | 120-350 |
| Stroke of mould board | 230 | |
| Max mould size(W×H) | mm | 360×360 |
| Mould thinkness | mm | 125-200 |
| Screw diameter | mm | 55/45 |
| Screw L/D ratio | L/D | 25/23 |
| Plasticising capacity | kg/h | 45/25 |
| Number of heating zone | zone | 3 |
| Extruder heating power | kw | 13.35 |
| Power of screw-bar machine | kw | 0.18 |
| Extruder driving power | kw | 11 |
| Number of heating zone | zone | 2 |
| Power of die heating | kw | 4.2 |
| Max die-pin diameter | mm | 75 |
| General power of machine | kw | 34.2 |
| Power of the electric motor of oil pump | kw | 5.5 |
| Air pressure | Mpa | 0.6-0.8 |
| Average energy consumption | kw | 23.9 |
| Using quantity of compression air | m3/min | 0.8-1 |
| Using quantity of cooling water | m3/min | 1.5-2 |
