Inside Construction Modern Porcelain Floor Tile Burning Stone Surface

 Burning Stone Surface Modern Simplicity House & Villa Building Inside Construction Floor Tile

 
 
Tile effect :
 


Guidelines: widely used in the living room, toilet, kitchen wall floor, flagship store, can also be laid outdoors.
Process characteristics: Can keep color for a long time, hard and wearable, suitable for use in most indoor spaces
except toilets and kitchens.
Glaze: Concave-convex grinding face plus flash glaze, non-slip, easy to clean.
Design pattern: Multiple patterns combination, can be mixed with multiple colors.
 
1, when opening the box, should recognize the product specifications, dimensions, color number, etc., the same color
number of the product affixed to the same position, do not mix the products of different color numbers together pasted
(unless consciously required to obtain Special decorative effects in the figure)
 
2, before pasting first on the ground test, after using the same color number and size, you can use the adjacent color
number and size, and different color number, size tile classification, and then in the bottom of the brick for use Number
to indicate. If the brick surface has a pattern or directional pattern, the product should be unified according to the direc
tion of the pattern, in order to best decorative effects.
 
3, at present, the tile pasting mostly uses wet pasting and dry pasting two methods.
 
4, when paving the floor brick, it is recommended that the surface area of cement mortar paving should not be too large,
so as not to find the surface cement mortar more than the initial coagulation time(about 45 minutes), resulting in the tile
and adhesive layer adhesion is not dense Real, causing quality problems such as air drums.
 
5, when leaving seam pasting, polished brick spacing 2mm-5mm is appropriate. The polished brick and the wall junction
leave a seam of 3mm-5mm.
 
6, pasting should be carried out after the base is compacted. When tiling tiles, the tiles and the pasting surface are first
presented at a certain angle(about 15 degrees), and then pushed gently to the horizontal direction by hand to balance
the bottom of the brick and the pasting surface.This facilitates the elimination of bubbles; Then tap the brick surface with
a hammer handle, so that the bottom of the brick can eat pulp, so as not to produce an empty drum phenomenon; Then
knock the brick surface to level with a wooden hammer and measure it with a horizontal ruler to ensure The tile pasting
level.
 
7, the product pasted for about 1 hour(depending on the climate and the degree of cement condensation), we must use
the wood bran or sponge to clean the cement mud in time, to avoid the surface contamination time is too long, it is diffic
ult to clean up.
 
8, about 12 hours after the product is pasted, hit the ground with a wooden hammer in time to check whether there is an
empty drum phenomenon. All brickwork should be done in time to remove the surface dirt, 24 hours before walking.
 
9, pasted tiles within 48 hours, it is best not to use large-scale waxing and other electric equipment, so as not to tile and
adhesive layer later shock and lead to unnecessary empty drum phenomenon.