Digital Control Paper Tube Making Machine / Paper Core Forming Machine

How to operate automatic intelligent numerical control paper pipe finishing machine:
First, turn on the machine: start the electrical isolating switch (set in front of the electric control cabinet), press EMERCENCY STOP RESET and READY TO RUN button, and turn the key to MACHINE to RUN (main workbench) to check the voltage (380V) and whether the current is correct and stable. Open the power switch of the hydraulic system (set on the main hydraulic drive) and check the oil level and pressure gauge of the main hydraulic drive system to show whether it is correct and stable. Open the pneumatic interception valve (set in the air intake pipe under the pneumatic control cabinet), check whether the pressure is correct (not less than 6.0bar), stability.

Second, set control: according to the type, thickness, length and width of the thin film arrangement, the cut menu is set up. File the corresponding BOPP film from PDF. The winding length and width of the corresponding specification film are set. Select the corresponding reel position, adjust the roller arm and press roll, and install the corresponding paper core.

Third, feeding, film and film: wear material: according to cutting plan requirements, in accordance with the traffic rules, according to the actual situation, in the time frame hanging out the corresponding parent roll, according to the choice of direction in the corona and the cutting machine of unwinding rack, and use the control button to clamp the steel core. Leave the steel core support arm and driving.
Membrane: when there is no film on the cutting machine, it is necessary to carry out the membrane. Using the slitting machine's film penetrating device and function key, one end of the original membrane is connected to the eye of the film penetrating ring chain, and the push through button is started, so that the film distributes along the cutting process and distributes evenly on each roller.
Answer: when the film film slitting machine, roll changing joint, using vacuum film, the first film will then start to work station position, the first artificial cutting machine on the traction roller film flattening and actuate the upper vacuum membrane, the adsorption film is smooth in the film table. Double-sided tape affixed film and the excess cut tape, adsorption unwinding frame of the film is flattened and start lower vacuum pump to make the film is smooth, with adhesive tape paper layer and flat adhesive film joints should be neat, wrinkle free, and then turn off the upper and lower vacuum pump, then turn off the answer.