7.4V 1.96in Electric Tying Machine Battery Powered Vegetable Plant Vine Tying Machine

Battery Powered Hand-held Electric Garden Tying Set with Plant Tape For Vegetable

Electric tying machine, a fast efficient, low maintenance machine with 4 tie settings.

Technical Specifications:

Motor: brushless

Voltage: 16.8 V

Weight: 1065g (including battery)

Tying diameter: up to 25 mm

Autonomy: 1 day, with 2 batteries provided

Battery: 16.8 V, 2000 mA

Working Temp: -10 to 60 degrees C

Belt attached spool holder for 200 m tie rolls

Can be used with 90 m tie rolls loaded into the machine or 200 m tie rolls with the belt attached spool holder.
 

Binding machine is only 410g, very convenient to take.
Cost recovery very fast. One binding machine can save 3 labors
Labor saving, it can bind 3-4 times more plant than by hand in a unit time.
Time saving: it cost less time, so when farmers busy with the planting, we can have more time to do the other things like sprinkle.
Increase the plant area because of it's high efficiency.

ACCESSORIES

►Charger

►hexagon bar wrench

►lubricant oil

►rope*2

FUNCTIONAL DESCRIPTION

Before turning on the power switch, always check that the charger is removed and that the binding arm of the tie machine is open.
►To start the tool, press the power switch and the power indicator is on.
►To stop use, press the power switch again, the switch will pop up and the power indicator is off.

TYING OD.
The maximum opening of the tie arm is the maximum diameter of the tie and the maximum tie must not exceed 50mm(1.96INCH), otherwise tool damage and / or possible damage.

Check the blade
►Before using the tool, check the blade for wear.
►Slow, worn blades can cause poor cuts, increase the difficulty of using the tool, and shorten its service life.

Adjust or replace the blade

►Press the handle slowly and check the upper and lower blades as normal, otherwise follow the method below.

1. Unscrew the inner hexagon screw with the attached hexagonal wrench；
2. Let the upper blade stick to the lower blade；
3. Re-tighten the inner hexagon screws.

►Make sure to use this thin washer when padded on some tool screws.
►When the upper blade is worn, follow the following method.
1. Remove the hexagon screw by using the attached hexagon wrench；
2. Remove the lock pin；
3. Remove the upper blade mounting seat；
4. Open the screw and replace the new blade；
5. After remounting the blade, install the blade.

OPERATION

1. Turn on the power switch and open the tool binding arm.

2. Place the things to be tied into the binding arm.

3. Press the handle and release to secure the front end of the rope to the lower blade.

4. Open the binding arm and remove the binding arm along with the rope.

5. Press the handle again to the end, and the blade cut off the rope and wrap the rope.After the handle is pressed to the bottom, it should be kept for about one second. Too short time may lead to unwinding and loose release; too long time may lead to the winding belt fracture and the binding failure.

6. Release the handle and tie complete.

SERVICE
1. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained.
2. Never service damaged battery packs. Service of battery packs should only be performed by the manufacturer or authorized service providers.
3. Follow instruction for lubricating and changing accessories.
4. Do not modify or attempt to repair the appliance or the battery pack except as indicated in the instructions for use and care.

Applicaton

This tool is suitable for loose fixation of wires.Such as the branches of plants and stent fixation, multilinear beam fixation, etc.