| DescriptionLD Series electromagnetic meter is a kind of electromagnetic
induction type flow meter, which consists of sensor and
intelligent signal conversion. it can measure the volume flow rate
of all kinds of conducting liquids including acid, alkali, salt and
strong corrosive liquids and pulp, mud, oars, sewage water and
liquid with solid. It is mainly applicable to petrochemical, steel,
electricity, metallurgy, textiles, food, paper and pharmaceutical
industries and the environmental protection and water conservancy
projects and other fields. |
Suitable tube caliber: DN25~DN2600(below DN25 unstandard) Electrode
material: 316L(stainless steel), HC, HB, Ti, Ta Suitable Medium:
Liquid with conductive ratio more than 5 μs/cm Measuring range:
0.1~10m/s (extendable to 15m/s) Upper limit of span: 0.5~10m/s.
1~5m/s recommended Accuracy class: 0.3%, 0.5%, 1.0% Output signal:
4~20mADC, load≤ 750Ω, 0~3kHz, 5V with source and changeable width.
High terminal and effective frequency output, RS485 interface
Operation pressure: 1.0MPa, 1.6MPa, 4.0MPa, 16MPa (special) Fluid
temperature: 20C~80C, 80C~130C, 130C~180C according to liner
material Environmental temperature: sensor40~80º C.
Transducer 15~50º C Environmental humidity: ≤85%RH (at 20º C) Cable
outlet size: M20x1.5 Power supply: 220VAC± 10%, 50Hz± 1Hz, 24VDC±
10% Power consumption: ≤8W Protection ratings Combined type:
IP65. Separate type: Sensor IP68, transducer IP65 Materials of
liner: PTFE, soft rubber etc Connection of flange:
GB911988(DIN2051, BS4504) Earthing material: 1Cr18Ni9Ti (stainless
steel), HC, Ti, Ta, Cu |