Active Member
|
[China]
Address: 2# Jinlong Rd. Baolong Industrial Zone, Longgang Dist. Shenzhen China 518000
Contact name:Tarik Lu
Forsentek Co., Limited |
|
|
Micro Button Load Cell 100lb 50lb 20 lb 10 lb Compression Force Measurement Transducer
Subminiature Button Load Cell FC8E is made of stainless steel based
on metal foil stain gauge technology intended for compression force
measurement. 1000 ohms high resistance strain gauge delivers better
stability compared to commonly used 350ohms gauges, miniature load
cell FC8E offers 0-11lb / 0-22lb / 0-45lb / 0-110lb
four measuring ranges to choose from.Small size button type
compression load cell FC8E is featured with only 8mm outer diameter
and 6mm total height which makes it extremely suitable
for force measurement applications with limited mounting
space.Typical applications for transducer FC8E are such
as clamping force measuremen, force overload protection, load
distribution analysis, pressing die force measurement, auto
equipment, assembly line and so on.
Dimensions(unit in milimeter)
Specifications
| Capacity | 50N / 5kg / 11 lb 100N / 10kg / 22 lbf 200N / 20kg / 44lbf 500N / 50kg / 110lb |
| Rated output | 1.0 mV/V |
| Excitation | 3-8V |
| Zero balance | ±0.1mV/V |
| Nonlinearity | ±1% of capacity |
| Hysteresis | ±1% of capacity |
| Nonrepeatability | ±0.5% of capacity |
| Creep(5min) | ±0.2% of capacity |
| Safe overload | 150% of capacity |
| Ultimate overload | 200% of capacity |
| Compensated temperature | -10...+40oC |
| Operating temperature | -20...+60oC |
| Temperature shift zero | ±0.05% R.O./oC |
| Temperature shift span | ±0.05% R.O./oC |
| Input resistance | 900±100 ohms |
| Output resistance | 900±100 ohms |
| Insulation resistance | >2000M ohms |
| Ingress protection | IP64 |
| Material of element | Stainless steel |
| Cable | Ø2*4000mm 4-core shielded |
| Wiring code | Red--Excitation+ Black--Excitation- Green--Signal+ White--Signal- |
Load cell zero output(Zero Balance):The output signal of the
loadcell with no-load applied,expressed in mV/V or as a percentage
of rated output.The zero output is caused by the stress during
strain gauge bonding,it can be handled during calibration or signal
processing without affecting the measurement accuracy.
A Load Cell is a transducer that converts force acting on it into electronic signal which is proportional to the applied force.The acting force causes deformation of the measuring element,the bonded strain gauge deforms accordingly which will cause the resistance change of the wheatstone bridge,under constant power supply,the output signal between Sig+ and Sig- will change proportionally,thus the force can be measured by measuring the output signal from the load cell which is normally within 0...+10mV for model FC8E. A signal conditioner can be used to convert mV signal into 0-5V / 0-10V / 4-20mA output, taking compression force transducer FC8E-500N working with amplifier FSC(0-5V)-24V for example, the force-voltage relationship will be 0-500N load VS 0-5V voltage, 1V corresponds to 100N load, 2V voltage corresponds to 200N force,and so on.
Micro Button Load Cell 100lb 50lb 20 lb 10 lb Compression Force
Measurement Transducer
