Forsentek Co., Limited |
|
Micro Load Cell 500N 200N 100N 50N Miniature Compression Force Sensor
Subminiature Force Sensor FC8E is made of stainless steel based on metal foil stain gauge
technology intended for compression force measurement. 1000 ohms
high resistance strain gauge delivers better stability compared to
commonly used 350ohms gauges, miniature load cell FC8E offers 50N /
100N / 200N / 500N four measuring ranges to choose from.Small
size button load cell FC8E is featured with only 8mm outer diameter
and 6mm total height which makes it extremely suitable
for force measurement applications with limited mounting
space.Typical applications for transducer FC8E are such
as clamping force measuremen,force overload protection,load
distribution analysis,pressing die force measurement,auto
equipment,assembly line and so on.
Dimensions(unit in milimeter)
Specifications
Capacity | 50N / 5kg / 11 lb 100N / 10kg / 22 lbf 200N / 20kg / 44lbf 300N / 30kg / 66 lbf 500N / 50kg / 110lb |
Rated output | 1.0 mV/V |
Excitation | 3-8V |
Zero balance | ±0.1mV/V |
Nonlinearity | ±1% R.O. |
Hysteresis | ±1% R.O. |
Nonrepeatability | ±0.5% R.O. |
Creep(5min) | ±0.2% R.O. |
Safe overload | 150% F.S. |
Ultimate overload | 200% F.S. |
Compensated temperature | -10...+40oC |
Operating temperature | -20...+60oC |
Temperature shift zero | ±0.05% R.O./oC |
Temperature shift span | ±0.05% R.O./oC |
Input resistance | 900±100 ohms |
Output resistance | 900±100 ohms |
Insulation resistance | >2000M ohms |
Ingress protection | IP64 |
Material of element | Stainless steel |
Cable | Ø2*4000mm 4-core shielded |
Wiring code | Red--Excitation+ Black--Excitation- Green--Signal+ White--Signal- |
A Load Cell is a transducer that converts force acting on it into
electronic signal which is proportional to the applied force.The
acting force causes deformation of the measuring element,the bonded
strain gauge deforms accordingly which will cause the resistance
change of the wheatstone bridge,under constant power supply,the
output signal between Sig+ and Sig- will change proportionally,thus
the force can be measured by measuring the output signal from the
load cell which is normally within 0...+10mV for model FC8E. A
signal conditioner can be used to convert mV signal into 0-5V /
0-10V / 4-20mA output, taking FC8E-500N working with amplifier
FSC(0-5V)-24V for example, the force-voltage relationship will be
0-500N load VS 0-5V voltage, 1V corresponds to 100N load, 2V
voltage corresponds to 200N force,and so on.
Subminiature compression load cell 500N 300N 200N 100N 50N button
load cell