Active Member
|
[China]
Address: 2# Jinlong Rd. Baolong Industrial Zone, Longgang Dist. Shenzhen China 518000
Contact name:Tarik Lu
Forsentek Co., Limited |
|
|
Shaft-to-shaft reaction torque sensor Inline type torque measurement transducer
Shaft to shaft reaction torque transducer FTB is a stationary type torque sensor intended for non-rotating
torque measurement in both clockwise and anticlockwise direction.
Shaft type torque meter FTB offers 0.5Nm / 1Nm / 2Nm / 3Nm /
5Nm / 10Nm / 20Nm / 30Nm / 50Nm / 100Nm ten rated capacities to
choose from, keyed shaft located on both sides can be used to
connect with drive device and load. Each sensor will include a
3m-long shielded cable with mating connector and an in-house
calibration certificate to guarantee the sensor's performance,
torque cell FTB can be modified or customized as per client’s
requirements.
Dimensions
Specifications
| Capacity | 0.5NM 1NM 2NM 3NM 5NM 10NM |
| Rated output | 1.5 mV/V |
| Excitation | 3-15V |
| Zero balance | ±0.05mV/V |
| Nonlinearity | ±0.2% R.O. |
| Hysteresis | ±0.2% R.O. |
| Nonrepeatability | ±0.05% R.O. |
| Creep(10min) | ±0.1% R.O. |
| Safe overload | 150% F.S. |
| Ultimate overload | 200% F.S. |
| Compensated temp. | -10...+40oC |
| Operating temp. | -20...+60oC |
| Temp. shift zero | ±0.02% R.O./oC |
| Temp. shift span | ±0.02% R.O./oC |
| Input resistance | 350(700) ohms |
| Output resistance | 350(700) ohms |
| Insulation resistance | >2000M ohms |
| Ingress protection | IP60 |
| Material of element | Aluminum alloy |
| Cable | Ø5*3000mm 4-core shielded |
| Wiring code | Red--Excitation+ Black--Excitation- |
A torque sensor is a transducer that converts mechanical torque into mV signal proportional to the applied torque.The acting torsion causes deformation of the measuring element,the bonded strain gage deforms accordingly which will cause the resistance change of the wheatstone bridge,under constant power supply, the output signal between Sig+ and Sig- will change proportionally,thus the moment can be measured by measuring the output signal from the transducer.The output range of shaft torque transducer FTB is normally within -20mV...+20mV, signal amplification may be required for most applications, a signal conditioner can be used to get -5~5V, 0-10V or 4-20mA output for easy data processing.
Click here to download datasheet
