Electric No Cylinder Medical Face Mask Making Machinery With 3 Line Energy Saving

Full Automatic Dust Medical Face pure electric no cylinder Mask Making Machine with 3 Line , Auto Surgical Face Mask Machine

Introduction of Raw Material Selection

Common medical masks: It consists of three layers of non-woven fabric, the inner layer is ordinary non-woven fabric; the outer layer is non-woven fabric with waterproof treatment, which is mainly used to isolate the liquid sprayed by patients; Electret-treated polypropylene melt blown nonwoven fabric.

Technical Parameters:

1. Equipment size: 6150mm (L) × 3720mm (W) × 1950mm (H) (excluding receiving line)

2. Appearance color: international standard warm gray 1C (DB standard color), according to this standard without special instructions

3. Equipment weight: ≤5000kg, ground load ≤500KG / m2；

4. Working power: equipment 220VAC ± 5 ﹪, 50HZ, rated power about 9KW

5. Compressed air: 0.5 ～ 0.7 MPa, the use flow rate is about 300L / min

6. Operating environment: temperature 10 ～ 35 ℃, humidity 5-35% HR, no flammable or corrosive gas Body, no dust (cleanliness no less than 100,000)

7. Production efficiency: 90-130PCS / MIN;

8. Equipment production pass rate: 99% (except when the incoming materials do not meet the requirements or the employees' improper operation is excluded)

9. Equipment failure rate: 2% (refers to the failure caused by the equipment itself)

Precautions

After production, it is sterilized by ethylene oxide and left to stand for 7 days. It is volatile and toxic after being sealed.