|
[China]
Trade Verify
Address: i City, No11, TangYan South road, Yanta District, Xi'an,Shaanxi,China.
Contact name:Evelyn Wang
Xi'an Kacise Optronics Co.,Ltd. |
|
Verified Suppliers
|
|
|
| Material | 304 stainless steel |
| Pressure Range | -0.1MPa~0.4MPa |
| Length range | 100~1400mm |
| Installation | thread mounting M20×1.5 or flange mounting, special specifications can be costomized |
| Probe diameter | φ16 |
| Working current | ＜10ma |
| Power Supply | DC5V, 9~36V |
| Wire | PVC material (PA corrugated pipe aacover is optional) |
| Explosion-proof grade | Explosion-proof ExdIIC T5 |
| Output signal | 4～20mA, 4～20mA superimposed HART communication, 485 communication, CAN bus communication |
| Accuracy | 0.01 |
| Operating Temperature | -40℃~+85 ℃ |
| Protection Grade | IP67 |
3. Installation method
The wiring method is as follows:
RS232: The sensor output in this way has 4 wires
Red 24V+
Black 24V-(RS232)
Blue RS232 (RXD) computer sender
Yellow RS232 (TXD) computer receiver
4 to 20 mA: The sensor output in this mode has 2 wires
Red 24V+
Black 24V-
0 to 5V: The sensor output in this mode has 3 wires.
Red 24V+
Black 24V-
Blue 0~5V voltage output
note:
There can only be one type of RS232/ 0-5V/4~20mA signal, and one of
them can be used arbitrarily.
The sensor uses microcomputer technology and can be directly used
for measurement of various weakly corrosive liquids without
calibration.
Installation of the sensor:
1 If it is an old car, the original sensor needs to be removed. The
new car is installed directly;
2 Please check the accessories before installation: flange, rubber
pad, O-ring, whether the screws are complete and consistent;
3 Place the O-ring on the root of the sensor;
4 Apply oil-resistant sealant to both sides of the rubber pad, and
then fix the hole position with the flange and the fuel tank
flange, and fix it with screws. When tightening, symmetrical
rotation should be applied to ensure uniform force in all
directions and avoid oil leakage. ;
5 Insert the sensor into the wrench to complete the sensor
installation.
6 Connect the power cable and communication cable separately
according to the definition;
7 Check that the line is normal, you can turn on the sensor power,
and the sensor can work normally.
4. Application
Used in fuel oil tank for truck
5. Feedback
6. Package
******************************************************************************************************************************************
Please send us emali for more information, we will reply you in 12
hours.
We will provide 12 months of warranty, and lifetime maintenance for
products.
Fully tested before delivery.
We supply high quality fuel level sensor, and provide high level
services.
We believe once cooperation can keep you as our friend. We look
forward your inquiries.
