DRV8825PWPR 3D Printer Components StepStick 3d Printer Stepper Motor Driver

The maximum current is 2.5A;Up to 32 subdivisions are supported;4-layer PCB board, better heat dissipation performance;The internal resistance of the chip is smaller, the heat generation is lower, and the heat dissipation is better.
1. Suitable for driving stepper motor below 8.2V ~ 45V 2.5A;2. Only simple step and direction control interface;3. Six different stepping modes: full, half, 1/4, 1/8, 1/16, 1/32;
4. The adjustable potentiometer can adjust the maximum current output to obtain a higher step rate;5. Automatic current attenuation mode detection / selection;
6. Overheat shutdown circuit, undervoltage lockout, cross current protection;
7. Ground short circuit protection and load short circuit protection
parameter:
Manufacturing process: SMT placement machine manufacturing, non-manual welding, higher yield, more stable performance
Suitable for:
Where the stepper motor needs to be driven.
It is a necessary module for building 3d printer, cnc, engraving machine and so on.
Supported 3D printers include Prusa Mendel, ultimaker, printbot, makerbot, etc.
You can refer to the following for Arduino code to directly drive the motor
colour: purple
Material: PCB
size: 1.5mmX2mm
Package Contents:
5 * DRV8825 stepper motor driver
5 * heat sink
Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.