TUV VDE Horizontal Flammability Tester UL ZY6030C Robot Cable Vertical Torsion

TUV VDE Horizontal Flammability Tester UL ZY6030C Robot Cable Vertical Torsion

Scope of application:

1.1 for high flexible cable detection requirements of TUV, VDE and UL. The machine structure for inline 3 location (and 6 station), mainly used for metal wire longitudinal installation after repeated torsion test, to detect the metal wire in the reverse torsion test under plastic deformation performance and show to defects.

Meet the standard:

2.1 standards of China robot industry alliance standard and other standard CRIA 0003.2-2016 "industrial robot special cable part 2: test method" standard requirements;

2.2 conform to the standard requirements of the appendix H of TUV lane 2 PfG 2577/08.16.

Main features:

3.1 PLC touch screen display

3.1.1 Parameter setting: the machine table controls the relevant parameters

3.1.2 Test conditions: test speed, test frequency, test Angle direction, control condition, etc

3.1.3 Test monitoring: current equipment operation state, such as actual speed, frequency, Angle, display date, ETC

3.2 No one was badly: equipment by monitoring the sample circuit, automatic judge samples on and off, detect circuit disconnected, can choose to suspend operation test equipment, and with sound and light warning, until after artificial check again continue to test

3.3 Special Fixture: according to the cable of different lines, it is equipped with suitable fixture

3.4 the machine performance: the Kunlun state LCD + mitsubishi PLC + panasonic servo motor, transmission parts adopt native to imported products, stable operation, large torque, high precision, long using life, low noise

3.5 Online monitoring: the points are divided into 3 groups, 6 pairs of interfaces for each group, which can meet 18 pairs of wires simultaneously. The wiring plate is installed above the sample of each station and convenient to connect the cable

Main :

4.1 test station:

4.3 Station

4.2 test method: vertical torsion, upper end fixation, after the sample is bypassed a diameter cylinder, fixed the bottom twist clamp

The maximum diameter of specimen: phi 3~20mm

4.4 test sample torsion speed: 0~60 beats per minute adjustable (note: the test cycle consists of 4 steps)

Digital Settings for bending Angle: 4.5 + 180 °

4.6 The distance between the clamp and torsion point: 50~500mm can be adjusted

4.7 control mode: touch screen control

Number of digits: 0-99999999 times

4.9 machine table material: adopt 45# quality steel structure

4.10 motor: Japanese panasonic servo motor

4.11 machine size: W1080*D900*H1430mm

4.12 power supply: 220V, 50/60Hz 10A parameters: