|
[China]
Trade Verify
Address: 5F, Building D South, Jinshenghui Science Park, No. 3, Dafu Road, Fucheng Street, Guanlan, Longhua District, Shenzhen, China
Contact name:Michael Guo
E-link China Technology Co., Ltd. |
|
Verified Suppliers
|
|
|
10kmSingle Mode Fiber SFP Optical Transceiver Module Support 40Gb / S QSFP+ PSM LR4
Description
The E-link LNK-QSFP-LR4-10KM is a Four-Channel, Pluggable, Parallel, Fiber-Optic QSFP+ Transceiver for InfiniBand QDR/DDR/SDR,10G/8G/4G/2G fiber channel , PCIe and SAS Applications.
The QSFP full-duplex optical module offers 4 independent transmit and receive channels, each capable of 10.3Gbps operation for an aggregate data rate of 40Gbps 10km using single mode fiber.
These modules are designed to operate over single mode fiber systems using 1310nm DFB laser array.
An optical fiber ribbon cable with an MPO/MTPTM connector can be plugged into the QSFP module receptacle.
QSFP+ PSM LR4 is one kind of parallel transceiver which provides increased port density and total system cost savings.
Features
● Four-channel full-duplex transceiver modules
●Transmission data rate up to 11.2Gbit/s per channel
●Up to 10km transmission of single mode fiber
●Low power consumption <2.5W,meet class 3
●Operating case temperature 0°C to +70°C
●3.3V power supply voltage
●RoHS 6 compliant
●Hot Pluggable QSFP form factor
●Single MPO connector receptacle
●Built-in digital diagnostic function
Applications
● InfiniBand QDR, DDR and SDR
● 40G Ethernet
● Proprietary High Speed Interconnections
● Data center
The operation in excess of any absolute maximum ratings might cause permanent damage to this module.
| Parameter | Symbol | Min | Max | Unit | Note |
| Storage Temperature | TST | -40 | 85 | degC | |
| Relative Humidity(non-condensing) | RH | 0 | 85 | % | |
| Operating Case Temperature | TOPC | 0 | 70 | degC | |
| Supply Voltage | VCC | -0.3 | 3.6 | V | |
| Input Voltage | Vin | -0.3 | Vcc+0.3 | V |
Recommended Operating Conditions and Supply Requirements
| Parameter | Symbol | Min | Typical | Max | Unit |
| Operating Case Temperature | TOPC | 0 | 70 | degC | |
| Power Supply Voltage | VCC | 3.13 | 3.3 | 3.47 | V |
| Power Consumption | - | 2.5 | W | ||
| Data Rate | DR | 10.3 | Gbps | ||
| Data Speed Tolerance | ∆DR | -100 | +100 | ppm | |
| Link Distance with G.652 | D | 0 | 10 | km |
Optical Characteristics
All parameters are specified under the recommended operating conditions with PRBS31 data pattern unless otherwise specified.
| Parameter | Symbol | Min | Typical | Max | Unit | Notes |
| Transmitter | ||||||
| Center Wavelength | λC | 1270 | 1310 | 1350 | nm | 1 |
| RMS Spectral Width | λrms | - | 3.5 | nm | 1 | |
| Average Launch Power, each lane | PAVG | -5.2 | -0.5 | +1.0 | dBm | |
| Optical Modulation Amplitude (OMA) | POMA | -4.5 | -0.5 | +2.0 | dBm | 1 |
| Difference in Launch Power between any two lanes | Ptx,diff | 5.0 | dB | |||
| Launch Power in OMA minus Transmitter and Dispersion Penalty (TDP), each Lane | OMA-TDP | -9.7 | - | dBm | 1 | |
| Rise/Fall Time | Tr/Tf | 50 | ps | |||
| Extinction Ratio | ER | 3.5 | dB | |||
| Relative Intensity Noise | Rin | -128 | dB/Hz | |||
| Optical Return Loss Tolerance | TOL | 12 | dB | |||
| Transmitter Reflectance | RT | -12 | dB | |||
| Transmitter Eye Mask Margin | EMM | 10 | % | 2 | ||
| Average Launch Power OFF Transmitter, each Lane | Poff | -30 | dBm | |||
| Transmitter Eye Mask Definition {X1, X2, X3, Y1, Y2, Y3} | {0.25, 0.4, 0.45, 0.25, 0.28, 0.4} | |||||
| Parameter | Symbol | Min | Typical | Max | Unit | Notes |
| Receiver | ||||||
Center Wavelength
| λC | 1270 | 1310 | 1350 | nm | |
| Damage Threshold | THd | +3 | dBm | |||
| Overload, each lane | OVL | +1 | dBm | |||
| Receiver Sensitivity in OMA, each Lane | SEN | -12.5 | dBm | |||
| Difference in Receive Power between any two Lanes (OMA) | Prx,diff | 5.0 | dB | |||
| Signal Loss Assert Threshold | LOSA | -30 | dBm | |||
| Signal Loss Deassert Threshold | LOSD | -15 | dBm | |||
| LOS Hysteresis | LOSH | 0.5 | 6 | dB | ||
| Optical Return Loss | ORL | -12 | dBm | |||
| Receive Electrical 3 dB upper Cutoff Frequency, each Lane | Fc | 12 | GHz | |||
Electrical Specifications
| Parameter | Symbol | Min | Typical | Max | Unit | |
| Differential input impedance | Zin | 90 | 100 | 110 | ohm | |
| Differential Output impedance | Zout | 90 | 100 | 110 | ohm | |
| Differential input voltage amplitude aAmplitude | ΔVin | 300 | 1100 | mVp-p | ||
| Differential output voltage amplitude | ΔVout | 500 | 800 | mVp-p | ||
| Bit Error Rate | BR | E-12 | ||||
| Input Logic Level High | VIH | 2.0 | VCC | V | ||
| Input Logic Level Low | VIL | 0 | 0.8 | V | ||
| Output Logic Level High | VOH | VCC-0.5 | VCC | V | ||
| Output Logic Level Low | VOL | 0 | 0.4 | V | ||
Pin Descriptions
| PIN | Logic | Symbol | Name/Description | Note |
| 1 | GND | Ground | 1 | |
| 2 | CML-I | Tx2n | Transmitter Inverted Data Input | |
| 3 | CML-I | Tx2p | Transmitter Non-Inverted Data output | |
| 4 | GND | Ground | 1 | |
| 5 | CML-I | Tx4n | Transmitter Inverted Data Input | |
| 6 | CML-I | Tx4p | Transmitter Non-Inverted Data output | |
| 7 | GND | Ground | 1 | |
| 8 | LVTLL-I | ModSelL | Module Select | |
| 9 | LVTLL-I | ResetL | Module Reset | |
| 10 | VccRx | ﹢3.3V Power Supply Receiver | 2 | |
| 11 | LVCMOS-I/O | SCL | 2-Wire Serial Interface Clock | |
| 12 | LVCMOS-I/O | SDA | 2-Wire Serial Interface Data | |
| 13 | GND | Ground | ||
| 14 | CML-O | Rx3p | Receiver Non-Inverted Data Output | |
| 15 | CML-O | Rx3n | Receiver Inverted Data Output | |
| 16 | GND | Ground | 1 | |
| 17 | CML-O | Rx1p | Receiver Non-Inverted Data Output | |
| 18 | CML-O | Rx1n | Receiver Inverted Data Output | |
| 19 | GND | Ground | 1 | |
| 20 | GND | Ground | 1 | |
| 21 | CML-O | Rx2n | Receiver Inverted Data Output | |
| 22 | CML-O | Rx2p | Receiver Non-Inverted Data Output | |
| 23 | GND | Ground | 1 | |
| 24 | CML-O | Rx4n | Receiver Inverted Data Output | 1 |
| 25 | CML-O | Rx4p | Receiver Non-Inverted Data Output | |
| 26 | GND | Ground | 1 | |
| 27 | LVTTL-O | ModPrsL | Module Present | |
| 28 | LVTTL-O | IntL | Interrupt | |
| 29 | VccTx | +3.3 V Power Supply transmitter | 2 | |
| 30 | Vcc1 | +3.3 V Power Supply | 2 | |
| 31 | LVTTL-I | LPMode | Low Power Mode | |
| 32 | GND | Ground | 1 | |
| 33 | CML-I | Tx3p | Transmitter Non-Inverted Data Input | |
| 34 | CML-I | Tx3n | Transmitter Inverted Data Output | |
| 35 | GND | Ground | 1 | |
| 36 | CML-I | Tx1p | Transmitter Non-Inverted Data Input | |
| 37 | CML-I | Tx1n | Transmitter Inverted Data Output | |
| 38 | GND | Ground | 1 |
