Fiberall Technology Limited |
|
FA-PP2000 Latest PP2000/LEXIA-3 Interface for Both Citroen and Peugeot with 5 Cables without 30P Conversion Cable
FA-PP2000 is a diagnostic scanner for comprehensive Citroen and
Peugeot cars diagnosis. The diagnostics software of PP2000 allows
you to perform complete diagnostics of all from 1995 until present
models. Diagnostics is performed via OBD-II connector (which is
located near steering wheel) or via manufacturer-specific connector
(only older cars, pre-2001).
Functions of PP2000/LEXIA-3 Interface:
Unlike other universal car scanner tools which only read fault
codes, this software performs nearly ALL the functions like the
original dealer diagnostic tool. Our diagnostic interface contains
K-Line multiplexor, CAN-BUS interfaces and SAE J1850 bus (both PWM
and VPW).
The following diagnostic functions are supported:
1.Read identification
Displays complete identification of control unit, e.g. part number,
software/hardware version, manufacturer, etc...
2.Read fault codes
Displays all stored and pending fault codes with complete
description (e.g. "Rail pressure - too low pressure").
Program supports report printing or copy to clipboard.
3.Clear fault codes
This function clears all stored fault codes and other diagnostic
information.
4.Auto-scan (complete car scan/test)
Detects all ECUs (electronic control units) installed in car and
reads all diagnostic fault codes.
5.Measured Values
Program displays live Data like Engine Speed, Battery voltage,
Oxygen Sensor, Coolant Temperature, etc. Values can be displayed in
graph, 9 values at once, or full listing (all measured values).
Logging to file is also supported, which allows offline analysis.
6.Actuator test
Actuator test activates particular actuator (e.g. turn on fuel
pump, lock/unlock wheel, lock/unlock doors, cut off fuel, etc..)
7.Programming functions/Adaptation
This feature is of great importance in all vehicles because systems
like Engine control units, Immobilizers, Airbags, Alarms, Body
Control Units, and some others, require you to perform reset or
programming procedures after car repair is done, or even
configuration after replacing broken Control Unit.
Hardware and software requirements:
Software requires at least Intel Celeron/Pentium III 400 MHz, 128
MB RAM, 50MB free HDD space and USB 1.1 port (USB 2.0 recommended)
and Microsoft Windows 98 SR2/2000/XP with the latest service pack
installed.
If customer requires, we can prepare ready to work PC.
Package includes:
Main unit with extension OBD2 cable
USB cable
Software CD for LEXIA-3 Version 45
Software CD for PP2000 Version 21
Instruction for Installation and Activation for PP2000
Note: The package do not include the 30pin to 16pin cable, if you need this cable, please order separately.
Please contact sales@fiberallchina.com for more detail or visit www.fiberall.net for more information.