API600 GATE VALVE HIGH PRESSURE 2500LB PRESSURE SEALING BONNET RTJ
FLANGE WCB BODY
The performance pressure seal bonnet gate valves Pressure seal bonnet gate valves have same application features as
bolted bonnet valves shown on the page. The major difference is
that the bonnet is designed for high-pressure, high-temperature
service.
The pressure seal bonnet joint eliminates the body/bonnet flanges
reducing weight and simnplifying the application of exterior
insulation. Contrary to bonnet valves. Internal pressure applied to
a pressure seal valves forces the sealing elements into tighter
contact the higher the internal pressure he tighter the seal. Gate valves may be installed without consideration for the
direction of flow. They are not recommended for use in a partially
open, throttling position because erosion, noise and execessive
wear can occur. Gate valves installations should always be made
with consideration for the potential of bonnet over-pressurization
caused by fluids which may become entrapped in the bonnet of a
closed valve. Where this possibility exists, it is the user's
responsibility to insure that proper venting is installed.
DONG-A VALVE cast steel pressure seal valves comply with the design
and test requirements of ASME B16.34 and the installation
dimensions of ASME B16.10. All DONG-A VALVE pressure seal gate valves have the features shown
below. They are engineered to provide convenience, durability and
maintainability.