150-27-00025 Floating Seal Floating SK200 PC150 SG3000 300*328*20

150-27-00025 Floating Seal Floating Oil Seal SK200 PC150 SG3000 300*328*20

150-27-00025 Floating Seal 3000 SK200 PC150 Steer Swing Motor Seal SG3000 300*328*20 Komatsu Kobelco Hitachi Seal Group

JHY-3000 is the best selling size of all the sizes of floating seal, even the world wide, this size is suit to many models:

PC200-35,E240,ZAX360 inject
EX300-2/1/3/5;SK200,200-5,220-5,
230-6steer,250-8,330,E320B/C/D,E200B.HD820,HD700SEV;
SH200;UH07-5,UH07-7,UH083;SH210-5 elec inject
ZAX330,EX300-5,PC150-5,C290,D60,DH300-7new version
SK07-2,SH280FJ2,DH220-7(fik line);HD700-5/7,
HD820-3,Sany215,PC220-7,CASE210.240.SHA1.A2Yuchai230(KYB),SK250LC Steer

3000 exact size is :300mm*328mm*20mm, it is a 4pcs couple type seal

Prevent forced installation. Do not use a hammer to knock in, but use a special tool to first press the sealing ring into the seat hole, and then use a simple cylinder to protect the lip through the spline. Before installation, apply some lubricating oil to the lips to facilitate installation and prevent burns during initial operation. Pay attention to cleaning.

Prevent overdue use. The service life of rubber seals for dynamic seals is generally 3000～5000h, and new seals should be replaced in time.

The size of the replacement seal should be the same. It is necessary to strictly follow the requirements of the instructions, and select the same size of the sealing ring, otherwise the tightness and other requirements cannot be guaranteed.

Avoid using old seals. When using a new sealing ring, carefully check its surface quality to ensure that there are no defects such as small holes, protrusions, cracks and grooves, and have sufficient elasticity before using it.

We require it to be good quality , and have nice packing

JHY-3000, OEM:150-27-00025

1 set 1 packing box

1. Do not open the seal package if unnecessary, otherwise the dust will stick to the seal or scratch it.
2. Store in cool place, not on sunlight place. UV and moisture will accelerate the deterioration of rubber and plastics and dimensional changes
3. Carefully pack, store unpackaged product, do not glue or put into impurities, keep the original state. Keep the Nylon seal package close to prevent moisture cause dimensional changes
4. Do not put seals near heat sources, such as boilers, stoves. Otherwise heat will accelerate the aging of seals
5. Do not put seals near the motor and other place where produces ozone
6. Do not use a needle, wire, rope hang seals, otherwise, would cause the seal deformation, damage the lip
7. Sometimes, there are color change or white powder on the seal surface (frost phenomenon), this will not affect the performance of the seal

We attend the exhibitions domestic and abroad