110v 300mm Anti Static Bar Static Control None Air Source For Electronics / Plastics

Installation

• Choose optimal location for discharge and fix the bar and power supply steadily.
• Connect earth to earth connect end on ion bar.
• Insert one end of the power cord into power adapter and the other end into power port.
• Connect air connector to air supply device with tube and turn on the air switch.
• Turn on the power switch and adjust proper air pressure.

Notice on use and safety warning 

• Read this manual carefully before installing and using of the device.
• Be sure the device reliable ground connected during use, otherwise may cause bar body burn.
• Touching of electrode tip during use strictly prohibited.
• Do not use this device in the environment where the humidity is greater than 75%.
• Input air must be clean and filled air without water, oil and dust particle
• It is strictly prohibited to use this equipment in combustible and explosive environment.
• Internal maintenance and repair must be carried out by professionals

Maintenance 

• User should clean and maintain timely to ensure the good performance of the product according to working environment and requirement of ESD protection. Clean the carbon materials on electrode tip, discharge pad and metal discharge body with static brush or clean cloth with ethanol can obviously improve the performance.

Caution

• Must be done after the power is shut done for 10 minutes
• Restart must wait till alcohol completely volatilized after cleaning by clean cloth with ethanol. Any other organic solution is not allowed to be used to clean the rod.

• Stop using when POS/NEG working indication keeps off. Re-use after check and repair by professionals.