Operating Voltage: AC180-240V (50Hz)
Product Power: 5W
Install Method: Embed
Output Flux: 400LM ±10
Product Size: Φ112mm x 47mm
Product Material: Aluminium+PC (milk cover)
LED Color Temperature: 3000 --- 6000K
Color Rendering Index: >75
Ambient Temperature: -20 ~ + 45℃
Gross Weight: 172g
Net Weight: 130g
Packing Material: Gold Stamping White Card
Guarantee: 2 years quality assurance
Approvals: CE,GMC,FCC
Color box size(mm): 116 x 116 x 55 (L x W x H)
Master ctn size(mm): 600 x 370 x 255 (L x W x H)
Master ctn quantity (pcs): 60
Master ctn net weight (kg): 6.2
Master ctn gross weight (kg): 8
LED Downlight instruction book
Precautions:
1: install at the flat place without shake and rocking, pay
attention to avoid falling from high, hitting by hard goods,
knocking.
2: before maintain, install or replace the fixture, to guarantee
the personal safety, have to cut off the power, make sure the
luminaire have installed correctly, then can connect the power.
3: the lamp can not be installed in the place with inflammable,
explosive, moisture, corrosive gas, operating environment
temperature is -20 ~ + 45℃, humidity≤80%, so as not to effect the
work lifespan.
4: using this leds lights can not run counter to any rule of fire protection, make sure
there is at least 75mm air-vent around, the surface lighted must be
part from the front of light at least 500mm, and make sure the
light will not be covered by insulation blanket or similar
material. 5: the products can be only used indoor, forbid using outdoor and
the place can be poured by rain.
6: if the lamp extinguish or flicker in using, please check if the
connection of light fixture is good. if no connection problem,
please ask for maintenance or replace.
7: any question about this instruction, please consult with the
engineer with qualification.
Caution:
in order to prevent the accidents which threaten the personal
safety, such as light broken, falling, electric shock, fire
breaking out etc, please install and use according to the
instruction strictly, don't remake the light and change the
component by yourself.
Installment instruction:
1: make a right size mounting hole on the ceiling, according to the
diagrammatic drawing to connect the power wire of the lamp with
electric supply. check and confirm the wire connection firmly.
2: press on the springs side by hand, embed the light into ceiling,
make the spring block on the ceiling.
3: connect the power on, the light can work.