Roof System is steel membrane like structure covering entire
building with panels joined together with a double lock standing
seam and a uniquely designed clip formed into the seam at the
building site in a unique manner that requires no
through fasteners or holes. The panels are joined and sealed together by a portable
electric seamer. This roof system is attached to the building with
a unique clip arrangement that requires no through panel fasteners
yet is securely attached to prevent wind blow off while allowing
the roof sheet to move allowing the roof sheet to move up to 60 mm
with thermal expansion and contraction without sacrificing
structural integrity. | |
Single Length Sheet up to 40 mts The sheets are custom rolled to any transportable length
maximum upto 13 meters. However, our specialized service of
On-Site Roll Forming enables single length sheet up to 40mts long,
without end laps - therefore on most jobs you can have single
sheet from ridge to eaves resulting into zero laps, which are
otherwise potential areas of leakage. Multicolor
recommends avoiding end laps for total maintenance free
roof. However if unavoidable two pieces clamped connection is
recommended to Seal end laps. Skilled Manpower and Intelligent Machine We execute the job from roll forming to erection of roofing with
quality and speed using best quality steel material. Environmentally Responsible The profile can be installed over an existing roof, and is
completely recyclable. Weather Tight Roof panels are permanently seamed together with a full 3600 double lock seam to keep moisture out and designed as water
and dust barrier. The raised seam assists drainage. | |
Roof Seamer The seaming process uses a heavy duty, Electric, portable roll
forming machine Called the Roof Seamer.
| |
Clip Design Roof clips securely attach the roof panels to the supporting
structural by stainless steel tabs which are roll formed into the
panel seam. Stainless steel tabs are than 50% stronger than other
galvanized standing seam tabs. The clip design allows for 32 mm of
movement in either direction to accommodate expansion and
contraction forces. This permits buildings up to 500 feet wide
without the need for special expansion joints. | |
Design Freedom High Strength It has 51 mm high ribs providing strength and beauty The
recommended minimum roof pitch for the profile is 20 ( 1 in 30 ). If the purlin and the roof plane are
perfectly align, Multi-Seam can be used for roof slope as low as 10. Steep Slope, Low Slope, and flat roof profiles can all be |