Active Member
|
Address: 23M,Shidai Bldg.,Linyuan road,Mianyang,sichuan
Phone: 86-816-6075677
Contact name:Mr. gus zhang
Mianyang Prochema Commercial Co.,Ltd. |
|
FEP coiler , FEP coil pipe, FEP snake tube, FEP pipe in coil
Introduction:
FEPtube is made from FEP resin and prepared by the technology of thermoplastic extrusion and blowing. It has non-sticking, heat-resistance, aging resistance, corrosive resistance, non-flammability and good electric property. It can be solid adhesive for PTFE and also a good adhesive for laminating various materials. Its working temperature is up to 200 and is an ideal material for circuit board and flat cable.
FEP coil pipe:
1 good cooling performance,
2 Corrosion resistance
3 large and bending around the curve,
4 long life cycle
Features:
The characteristic is a large and bending around the curve, since the minimum bend radius increases with the pipe diameter.
Uses:
Properties :
High low temperature resistance:
-200--200°C,high temperature strength is 2 times higher than PTFE
Good adhesive and heat sealability with PTFE:
Below melting point ,it won’t stick any project.Above melting point, it has perfect adhesive property with PTFE, Metal and self-adhesion(heat sealing).
None stick to water ,oil :water contact angle:θ=1150o
Electric reliability,High dielectric
60HZ-60MHZ,Under the high and low temperature,thepermittivitykeeps2.1even if the surface damaged ,it won’t has conductive track.
Volume resistance>1018ΩM
Surface resistance>2*1013Ω
Voltaic Arc Resistance>165sNo electric leakageWeather resistance:It can be used in sunlight and ozone long
Anti-corrosion:Only in high temperature, Fluorin and alkalis can effect it,others
acid,alkali or ester won’t effect it.
Fireproof :If firing, and will still insulate .
High diaphaneity
UL-Resistance :Good penetrability in ultraviolet radiation,and lowest refraction coefficient
Technical index of FEP:
| Item | Value | ||
| General purpose | Electric purpose | ||
| Density g/cm3 | 2.12-2.17 | 2.12-2.17 | |
| Temperature range°C | -200 -+200 | -200 -+200 | |
| Longi&tray,shrink rate %≤ | 3.0 | 3.0 | |
| Tensile strength Mpa ≥ | 14 | 14 | |
| Elongation at break %≤ | 175 | 175 | |
| Tear Strength (N/m) ≥ | 4.9x104 | 4.9x104 | |
| Dielectric Constanct (106Hz) | 2.15 | ||
| Dissipation Factor 106Hz≤ | 1x10-3 | ||
| Volume resistance (Ω.m) | 1x1014 | ||
Dielectric StrengthTH≤0.05mm Th 0.05-0.1mm M/VTH ≥0.1mm | 100 | ||
| 75 | |||
| 50 | |||
Specification
Dia ø1.5 --300mm, Thickness: 0.015mm to 0.75mm. Length :50mm to unlimited.
For UV lamp T4 T5 T8 T10 T12 , Thickness 0.2 to 0.5mm .
Color and sizes can be customiszed .Surface treated can be done (chemical or plasma treated)
Plastic bag &carton . Customized is acceptable
