SRC040 RC Drill Bit diameter 124mm For Geologic Exploration

SRC040 Fast and Continuous Reverse Circulation RC Drill Bit For Sample Drilling

Product Introduce:

Much like air core drilling, RC drilling returns cutting to the surface through an inner tube inside the rod. This is achieved by blowing air down the rods at a rate up to 1500 Pascals. This creates a pressure differential that pushes cuttings and water up via air lift.

The drilling component is powered by a pneumatic reciprocating piston (also known as the hammer), which drives a steel drill bit.

The two most commonly used drilling bits in RC systems are the fixed cutter and roller cone, both of which are advantageous depending on the project and geographical location of the site.

RC drilling is primarily used on large machinery and drill rigs and often goes to depths of 500 meters.

High quality RC equipment also has the ability to dry out the rock with large air compressors before the drill hits, which provides dry rock chips and, in turn, better samples.

Detailed Photo:

About us:

SOLLROC Reverse Circulation drilling (RC) ,from size 3’’ to 5.5’’, is a technique of drilling that uses dual wall drill rods that consist of an outer drill rod with an inner tube. By using compressed air to extract rock fragments sample,the samples travel through rods to a sample splitter at surface, avoiding all contact between the samples and the borehole wall that allows samples to be retrieved with minimal contamination,which is mainly used in deep hole exploration and mining grade control.

Delivery Way:

By Air, By express or By Sea