Active Member
|
[China]
Address: NO11,Changchun Road, Hi-tech Zone Zhengzhou,China
Contact name:doritdental
Henan Dorit Biotechnology Co., Ltd. |
|
|
Dorit Compatible NSK Type Quick Coupling Led Dental Optical
Fiber High Speed Handpiece
dental handpiece nsk
1.German spindle and bearing, great clamping force
2. New design of air-in system, better airflow
3. Fiber optic light, more brightness
4. Three water spraying outlets
5. Nsk handpiece 2 hole / 4 hole
Nsk handpiece Technical data:
| Products Name | High Speed Nsk Handpiece |
| Water Spray | Triple spray |
| Drive air pressure | 0.25-0.3Mpa |
| Water pressure | 0.2Mpa |
| Water pressure | 198Kpa(2kg) |
| Light brightness | 25500lux |
| Power | 22W |
| Rotation speed | 300,000~420,000rpm |
| Head height | 13.1mm |
| Head diameter | Φ11mm |
| Chuck type | Push button |
| Clamping force | 22N~34N |
| Torque force | 0.1N·cm |
| Bur Applicable | Φ1.59mm-Φ1.6mm*21mm-23mm(diameter*length) |
| Noise | ≤60DB |
Detailed photos:
Fiber optic light, great brightness Special design for easy holding |
3 water spray, ideal cooling effect |
NSK ype 6 holes ISO Standard quick coupling |
dental High Speed fiber optic turbine handpiece with NSK type 6 hole led coupling |
Company information
We are manufacturer for producing and supplying high speed dental handpiece , low speed dental handpiece, dental implant handpiece, endodontic files, and other relative dental instruments for many years .OEM & ODM orders are available , if you do not find the right items you are looking for,kindly please leave us message , we will reply you within 24hours .Thanks!
After each patient use , maintenance should be done as follows:
1. First remove the diamond burs , and clean up all the teeth on dental handpieces precipitate
2. Use a metal needle to clean the spray holes and fumaroles
Note: The spray holes and diamond burs into 40 -degree angle , fumaroles and diamond burs to a 30 degree angle
3. Place the clean lubricating oil is sprayed into the axial hole 1-2 seconds ( diamond burs is plugged holes )
4. In the bottom of the handpiece were ( with / without quick connector ) two kinds of styling , make the right amount of lubricant is injected into the bottom
5. The handpiece with quick connector combination ( first determine the water switch is turned off )
6. Replace the diamond burs , surrounded by white silk cloth handpiece head ( make sure the needle does not touch the diamond burs and white gauze , so as not to tie )
7. pedal depressed for about 20 seconds , look at whether there is in white gauze on any stain. If there are stains on the white gauze , again, add oil , starting from item 4 continued routine maintenance , know that white gauze until no stain
8. Finally, no more than 135 degrees Celsius temperature and high pressure sterilization
